Expo on a buddy box
 

Danny, I'm using a 6102 as a master and a X 347 as the slave (buddy box). Can I program in some expo on the 347? I've tried but it doesn't seem to be working. I'd like to make the buddy box's stick a little less sensitive.

RE: Expo on a buddy box
 

Yes, you can either enter the expo into the 347 and use the standard trainer set up of the 6102, but remember that the 347 does need to be completely set up for the model in this mode. The 6102 also has a pilot link function, so that if you are using it as the master, you could use the pilot link function and then when the trainer button is pressed, only the 4 primary controls are reliquished to the slave 347 and the programming features set up in the 6102 would remain active. So the expo would also carry through to the 347.

RE: Expo on a buddy box
 

Thanks Danny! As usual you have told me exactly what I wanted to know. Since I just got the 6102 I'll give the Pilot Link a try. It's good to know that if I decide to go with a Quattro buddy box I can use the expo from the 6102.

RE: Expo on a buddy box
 

No problem! Please let us know if you have any further questions.