140k a bit of flame on start up
#1
Thread Starter
140k a bit of flame on start up
Hi guys
I just installed a new 140K running on kero. On start up I have some yellow flame. She settles then is a bit slow to accelerate. She hangs around 17k. Just wondering what parameters I should start looking at fine tuning. Any help would be appreciated as I am not that familiar with Fadec.
thanks
Dean
I just installed a new 140K running on kero. On start up I have some yellow flame. She settles then is a bit slow to accelerate. She hangs around 17k. Just wondering what parameters I should start looking at fine tuning. Any help would be appreciated as I am not that familiar with Fadec.
thanks
Dean