k 80 RPM trouble
#1
Thread Starter
My Feedback: (10)
k 80 RPM trouble
I have a K 80 that has been showing erroneous RPMs at start up and after the engine has been running for a few minutes .
As soon as the hand data terminal "reads "glow plug test," the HDT reads 64,000 RPMs and then it will read normal during the spin up. After it goes into "running " mode, the engine runs fine for a while during taxi and then , all of a sudden , the engine starts increasing power on it's own without my input . I'll apply brakes and go over to it and hook up the HDT and notice that the HDT reads 0 RPMs and then , the engine will shut down . And ideas on what could be the problem will be greatly appreciated .
Steve
As soon as the hand data terminal "reads "glow plug test," the HDT reads 64,000 RPMs and then it will read normal during the spin up. After it goes into "running " mode, the engine runs fine for a while during taxi and then , all of a sudden , the engine starts increasing power on it's own without my input . I'll apply brakes and go over to it and hook up the HDT and notice that the HDT reads 0 RPMs and then , the engine will shut down . And ideas on what could be the problem will be greatly appreciated .
Steve