Top Flite Giant P-47 Build
#2277
#2278
Last week I got awaited package. Now I´m thinking about the right warbird. One of the options is get back to my La-5FN and finish the new fuselage another one is TF P-47.
Why I see the Saito FG60 with the Keleo ring mufflers? I studied 2, 4stroke and jet engines for 5 years and remember, that any muffler for 4stroke engines is useless without any effect for power of the engine.
Why I see the Saito FG60 with the Keleo ring mufflers? I studied 2, 4stroke and jet engines for 5 years and remember, that any muffler for 4stroke engines is useless without any effect for power of the engine.
#2281
I wasn´t satisfied with the old design of my gunsight Mark 8. It was good when I listed, it was almost 10 years ago, but now I am able to make another one. Better and scale.
Here are some pictures of the design.
Here are some pictures of the design.
#2282
Yesterday I took the TF kit from second hand. The guy who started the project desined the wings and fuselage for China retracts. It would be difficult to replaced them and use the Robart retracts. We will see, if they would be good for this Jug. I prefer the Razorback, going to make the ridge.
#2284
When I was thinking about TopFlite Giant P-47 I wanted the Razorback. That one I took was build as bubble top. A while I was thinking and tried search some bubble top paint scheme I like. But I decided to convert the jug to Razorback. The formers were still in box, well I removed the sheeting and attached the back formers.
#2290
Here are some actuall shots. I´m still working on the back. Now I´m not sure how to fill in the gap between the canopy and balsa sheeting. I found the two strips of the balsa, but it would be necessary to add another sheeting. Anybody can advice or post some pictures of the TF P-47 kit?
#2291
Thread Starter
My Feedback: (6)
Have a look at post #939 in this thread by doomking. Should be pretty easy with scrap balsa and some filler.
http://www.rcuniverse.com/forum/11355133-post939.html
http://www.rcuniverse.com/forum/11355133-post939.html
#2294
Some progress. The back is sanded. I suppose it would be better to make some update on that kit and design new ribs. The top of the back could be covered by 2mm balsa sheets.
#2298
A little more CAD 3D designing. I have the TopFlite cockpit kit for my TF Razorback, but I´m not satisfied with the quality and ABS parts. I decided to make some parts for the cokpit. As you probably mentioned the gunsight is done. Last day I did the trim control unit.