Balsa USA Brotherhood
#201
Senior Member
My Feedback: (5)
Just went to their website as you almost made me think that I was loosing my mind. Went on the page where they list all of the products that they offer. They have a listing just for " DUMMY ENGINES ".
Kindly try again, I think it is listed under CATALOG. You will find it and you might find what you are looking for.
Last edited by Granpooba; 05-05-2014 at 01:32 PM.
#202
Senior Member
Thread Starter
Well, my eye sight is pretty bad, but yours must be even worse. Haahahaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
Just went to their website as you almost made me think that I was loosing my mind. Went on the page where they list all of the products that they offer. They have a listing just for " DUMMY ENGINES ".
Kindly try again, I think it is listed under CATALOG. You will find it and you might find what you are looking for.
Just went to their website as you almost made me think that I was loosing my mind. Went on the page where they list all of the products that they offer. They have a listing just for " DUMMY ENGINES ".
Kindly try again, I think it is listed under CATALOG. You will find it and you might find what you are looking for.
Here is the Mick Reeves one, it looks more detailed but it's 300g
http://www.mickreevesmodels.co.uk/~m...es/p2bipe.html
#204
My Feedback: (38)
Here is a shot of my third scale DR1 just maidened yesterday.....first take off! Built and covered by Brian Hole and painted by me.
Flies great! I have flown many BUSA kits over the years, including the original Phaeton bipe, swizzle stick, small Taube, big Fly Baby, big Eindecker 1/4 scale Pup, 1/3 scale Nieuport 17, with the most memorable being the both of my 1/3 scale Pups. I might have missed a couple along the way...oh yeah, the Bristol, too.
May I have a number?
#205
Junior Member
Join Date: Apr 2014
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
Well, my eye sight is pretty bad, but yours must be even worse. Haahahaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
Just went to their website as you almost made me think that I was loosing my mind. Went on the page where they list all of the products that they offer. They have a listing just for " DUMMY ENGINES ".
Kindly try again, I think it is listed under CATALOG. You will find it and you might find what you are looking for.
Just went to their website as you almost made me think that I was loosing my mind. Went on the page where they list all of the products that they offer. They have a listing just for " DUMMY ENGINES ".
Kindly try again, I think it is listed under CATALOG. You will find it and you might find what you are looking for.
Nothing wrong with your eyesight at all Granpooba, though I might now have my sight rechecked, rather embarrassing
#206
Senior Member
Thread Starter
BUSA brothers
#1 3136 Victoria, Australia
#2 Jeffo MI USA
#3 ARUP KY USA
#4 RCKen OK USA
#5 mattnew MA USA
#6 surmovik60 VA USA
#7 GerKonig PA USA
#8 Granpooba NY USA
#9 radfordc KS USA
#10 balsa brain FL USA
#11 jwrich OK USA
#12 wwoneguy MD USA
#13 vertical grimmace CO USA
#14 rcmiket TX USA
#15 bpoates25 FL USA
#16 PiperDriver IL USA
#17 68goat AL USA
#18 jlsimon NJ USA
#19 pat s NC USA
#20 pending IN USA
#21 Steve Percifield IN USA
#22 opol MN USA
#23 Zero TX USA
#24 tonyos VA USA
#25 b206 IL USA USA
#26 LonnieMcc MS USA
#27 eindecer3 TN USA
#28 flyer35 NY USA
#29 jeffEE MN USA
#30 s3nfo CA USA
#31 Kwikfli KS USA
#32 JDHammer PA USA
#33 Ikruse OK USA
#34 bobbailey VA USA
#35 Vampire PA USA
#36 zemkes_wolfpack IN USA
#37 triumphman49 AL USA
#38 SRQFlyer FL USA
#39 Daniel-EL OH USA
#40 hairy46 WY USA
#41 pettit NC USA
#42 Hrannar Iceland
#43 lowbubba OH USA
#45 FokkerD7 OH USA
#44 FireBee VA USA
#46 iampilot2 OH USA
#47 Wagon1 FL USA
#48 darren 4 WI USA
#49 Luxuswaffe FL USA
#50 dryverman VT USA
#51 otterrc FL USA
#52 cooper998 DE USA
#53 lazyace NY USA
#54 wings2an3 NY USA
#55 the pamster TX USA
#56 lucasar15 PA USA
#57 AMA74894 MN USA
#58 squidman TX USA
#59 M_Callahan OH USA
#60 Karp050555 PA USA
#61 optech CA USA
#62 pending NSW Australia
#63 R/C Art IN USA
#64 on_your_six MD USA
#65 Highflyer2 GA USA
Welcome R/C Art, that's quite a selection of kits, that DR1 looks fantastic.
#1 3136 Victoria, Australia
#2 Jeffo MI USA
#3 ARUP KY USA
#4 RCKen OK USA
#5 mattnew MA USA
#6 surmovik60 VA USA
#7 GerKonig PA USA
#8 Granpooba NY USA
#9 radfordc KS USA
#10 balsa brain FL USA
#11 jwrich OK USA
#12 wwoneguy MD USA
#13 vertical grimmace CO USA
#14 rcmiket TX USA
#15 bpoates25 FL USA
#16 PiperDriver IL USA
#17 68goat AL USA
#18 jlsimon NJ USA
#19 pat s NC USA
#20 pending IN USA
#21 Steve Percifield IN USA
#22 opol MN USA
#23 Zero TX USA
#24 tonyos VA USA
#25 b206 IL USA USA
#26 LonnieMcc MS USA
#27 eindecer3 TN USA
#28 flyer35 NY USA
#29 jeffEE MN USA
#30 s3nfo CA USA
#31 Kwikfli KS USA
#32 JDHammer PA USA
#33 Ikruse OK USA
#34 bobbailey VA USA
#35 Vampire PA USA
#36 zemkes_wolfpack IN USA
#37 triumphman49 AL USA
#38 SRQFlyer FL USA
#39 Daniel-EL OH USA
#40 hairy46 WY USA
#41 pettit NC USA
#42 Hrannar Iceland
#43 lowbubba OH USA
#45 FokkerD7 OH USA
#44 FireBee VA USA
#46 iampilot2 OH USA
#47 Wagon1 FL USA
#48 darren 4 WI USA
#49 Luxuswaffe FL USA
#50 dryverman VT USA
#51 otterrc FL USA
#52 cooper998 DE USA
#53 lazyace NY USA
#54 wings2an3 NY USA
#55 the pamster TX USA
#56 lucasar15 PA USA
#57 AMA74894 MN USA
#58 squidman TX USA
#59 M_Callahan OH USA
#60 Karp050555 PA USA
#61 optech CA USA
#62 pending NSW Australia
#63 R/C Art IN USA
#64 on_your_six MD USA
#65 Highflyer2 GA USA
Welcome R/C Art, that's quite a selection of kits, that DR1 looks fantastic.
Last edited by 3136; 05-08-2014 at 02:09 PM.
#208
Senior Member
My Feedback: (5)
Granpooba, did you use the 1/4 rotary? If so did you happen to weigh it?
Here is the Mick Reeves one, it looks more detailed but it's 300g
http://www.mickreevesmodels.co.uk/~m...es/p2bipe.html
Here is the Mick Reeves one, it looks more detailed but it's 300g
http://www.mickreevesmodels.co.uk/~m...es/p2bipe.html
From what I have been told the Eindecker had a rotary engine, which I assume means that the whole engine rotated around the shaft. They could not supply me with an engine like that, but what they did give me was an engine that only an expert would know the difference.
I also purchase a cowling and cowling cheeks from Fiberglass Specialties, as I did not care for what was supplied in the kit.
#210
Senior Member
Thread Starter
#212
My Feedback: (11)
I would like to submit my application (in triplicate) for the Balsa USA brotherhood. I have a 1/4 Sopwith Pup built by WWONEGUY and a D7 in kit form with drool markings . I am ever hopeful that I can be accepted into such an organization with such standards and degenerate moral turpitude.
#213
Senior Member
My Feedback: (5)
Yup, seen that quite a few times in the Crocodile Dundee movies. Hahahaaaaaaaaaaaaaaaaaaaa
But to tell you the truth, always would have liked to have visited your country. Perhaps someday it will happen. If it does, put one on the Barbie for me, please.
#214
Senior Member
Thread Starter
I would like to submit my application (in triplicate) for the Balsa USA brotherhood. I have a 1/4 Sopwith Pup built by WWONEGUY and a D7 in kit form with drool markings . I am ever hopeful that I can be accepted into such an organization with such standards and degenerate moral turpitude.
#215
Senior Member
Thread Starter
Ahhhhhhhhhhhhhhhhhhhh Haaaaaaaaaaaaaaaaaaaaaaaaaaaaaa ............... the Ole Aussie Hangover excuse.
Yup, seen that quite a few times in the Crocodile Dundee movies. Hahahaaaaaaaaaaaaaaaaaaaa
But to tell you the truth, always would have liked to have visited your country. Perhaps someday it will happen. If it does, put one on the Barbie for me, please.
Yup, seen that quite a few times in the Crocodile Dundee movies. Hahahaaaaaaaaaaaaaaaaaaaa
But to tell you the truth, always would have liked to have visited your country. Perhaps someday it will happen. If it does, put one on the Barbie for me, please.
and cool forrest areas where it can snow down the south (that's where I am)
#218
Senior Member
Thread Starter
What are you sooking about at least you can play snowball fights.
#220
Senior Member
My Feedback: (5)
Snow ball fights Yea right ! Hahhaaaaaaaaaaaaaa
Just turned 71 years old and this past winter went out and purchased all new skis, boots, helmet, goggles, etc. Decided that if we are going to have winters like this, I might as well pursue one of my old sports of skiing.
Just turned 71 years old and this past winter went out and purchased all new skis, boots, helmet, goggles, etc. Decided that if we are going to have winters like this, I might as well pursue one of my old sports of skiing.
#221
Senior Member
My Feedback: (5)
NOTICE :
Do not know how many of you folks in the Northeast realize this, but on May 17 & 18 their will be a Fun Fly at the Old Rhinebeck Aerodrome in New York state.
I realize that it may be quite a drive for lots of folks, but it may very well be worth it.
From what I have read, this fun fly is only for vintage & World War I aircraft and aircraft prior to World War II.
Some information can be obtained from the following:
Mr. Warren Batson Email: [email protected]
or :
www.mhrcs.com
Do not know how many of you folks in the Northeast realize this, but on May 17 & 18 their will be a Fun Fly at the Old Rhinebeck Aerodrome in New York state.
I realize that it may be quite a drive for lots of folks, but it may very well be worth it.
From what I have read, this fun fly is only for vintage & World War I aircraft and aircraft prior to World War II.
Some information can be obtained from the following:
Mr. Warren Batson Email: [email protected]
or :
www.mhrcs.com
Last edited by Granpooba; 05-08-2014 at 09:24 AM.
#224
My Feedback: (38)
Yes, that is correct. I can't remember who the pilot was or the country,(when you get old sometimes you forget stuff) but the personal markings were left on the plane and the roundels and rudder were overpainted with German markings. There is some pretty good information in "Nieuports in Action" and also the Windsock Data File on Niueport Fighters.
#225
Senior Member
Thread Starter
Snow ball fights Yea right ! Hahhaaaaaaaaaaaaaa
Just turned 71 years old and this past winter went out and purchased all new skis, boots, helmet, goggles, etc. Decided that if we are going to have winters like this, I might as well pursue one of my old sports of skiing.
Just turned 71 years old and this past winter went out and purchased all new skis, boots, helmet, goggles, etc. Decided that if we are going to have winters like this, I might as well pursue one of my old sports of skiing.