Building 3 Sig Hummers from Plans
#1
Thread Starter
Join Date: Jan 2009
Location: Katy, TX
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
#4
Thread Starter
Join Date: Jan 2009
Location: Katy, TX
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
First wing.. I decided to put just about 2 or 3 degrees of dihedral in this one The other 2 will be built according to plan as 1 piece.
All the major parts cut....
This is when I decided to do 3 I'll skip most of the steps for the other 2 planes but you will see them from now on.
Assembling the fuselages - doublers and formers.
All the major parts cut....
This is when I decided to do 3 I'll skip most of the steps for the other 2 planes but you will see them from now on.
Assembling the fuselages - doublers and formers.
#6
Thread Starter
Join Date: Jan 2009
Location: Katy, TX
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
Second one piece wing with the first (with dihedral) halves being assembled.
Another picture with all parts lined up.. (SORRY THIS ONE OUT OF ORDER BEFORE SHEETING)
Starting to cover the first Fuselage.
Covered fuse and tail feathers with other parts and planes.
Mocking up with wing.
Full mock up with tail feathers glued, and 3d printed gear and wheels.
Another picture with all parts lined up.. (SORRY THIS ONE OUT OF ORDER BEFORE SHEETING)
Starting to cover the first Fuselage.
Covered fuse and tail feathers with other parts and planes.
Mocking up with wing.
Full mock up with tail feathers glued, and 3d printed gear and wheels.