plane1940

HI - I am new to this site, so please excuse me if I am on the wrong forum and not asking the right question. I bought a House of Balsa P51D Mustang Kit . It is a old kit I understand. My problem is the kit is missing the plans. The instructions are in it (photo copy only). If someone could direct me to or might have these plans would reply. The wing span 49 inches, Area 425sq. inches and motor size 29 to 40. Again it is a P51D Mustang and Stand of Scale.
Thanks in advance

CafeenMan

Somebody here has the plans and will most likely make a copy for you. This forum is as good of a place as any to ask. If nobody replies in a week or so bump up the thread and maybe somebody who hasn't seen it will respond. Also, you may want to change your thread title to

"HOB .20 P-51 Plans Needed"

crook

I have the House of Balsa p51 mustang 1/12th scale .....but it is only 36in wingspan..you must have the bigger one...not sure if plans are similair....but it is just a little guide phamplet and the big scale print..

WillySLC

Hi,

I realize that this thread is quite old, but we have the plans for this model but we need the instruction book. We would gladly make you a copy of the plans if you can do the same for the instrustions.

Thanks,

Bill

plane1940

Hi
Thanks for the offer, but I have already recieved plans from the people from House of Balsa people. (via this site) I have the instructions and you are more then welcome to have a copy. They are a copy and not to clear or I could scan them and send to you via email. You email me your address and I can mail them to you.
Jake