mounting rimfire motor
07-21-2006, 04:58 PM
#1
Thread Starter
My Feedback: (11)
Join Date: Sep 2002
Location: holland,
MI
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
mounting rimfire motor
Hello, I'm building a Faltout for a fellow club member and need an answer for mounting the rimfire. The motor has a wheel collar on the back of it, that is too big to fit in the hold on the stock motor mount. I can take the collar off and there is a clip on the shaft to prevent it from sliding off. Is this sufficient, or do I need to drill out the hold in the mount? Please tell me what everyone else has done. Thank you
