Losi XXL out of ideas on starting problems
01-20-2013, 01:44 PM
#1
Junior Member
Thread Starter
Join Date: Jan 2013
Location: , MI
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Losi XXL out of ideas on starting problems
Every time I start my Losi XXL truck the engine takes off at full throttle.
I've replaced all hoses, rebuilt carb, replaced fuel tank etc.
I've disconnected the throttle connection and tried that by hand, no go.
I'm out of ideason what it could be, I've reset everything to factory defaults.
But it's always the same the moment the engine starts it's full throttle.
HELP.
I've replaced all hoses, rebuilt carb, replaced fuel tank etc.
I've disconnected the throttle connection and tried that by hand, no go.
I'm out of ideason what it could be, I've reset everything to factory defaults.
But it's always the same the moment the engine starts it's full throttle.
HELP.
01-23-2013, 10:50 PM
#2
RE: Losi XXL out of ideas on starting problems
if your carb is closed other then the 1mm gap and it wants to go full throttle id say you have a air leak somewhere
this guys video should help http://www.youtube.com/watch?v=thEln8jrmhk
this guys video should help http://www.youtube.com/watch?v=thEln8jrmhk
01-24-2013, 12:23 AM
#3
RE: Losi XXL out of ideas on starting problems
If its brand new, call Losi.
You are having the transmitter turned on (with charged batteries) before the receiver (again, batteries charged) in the truck? Stupid question I know, but ya have to check the obvious first. Did you Bind the receiver?! 2.4GHz radios need to be bound to a receiver to work. If this wasn't done, do it. Read the manual on how to do it.
You are having the transmitter turned on (with charged batteries) before the receiver (again, batteries charged) in the truck? Stupid question I know, but ya have to check the obvious first. Did you Bind the receiver?! 2.4GHz radios need to be bound to a receiver to work. If this wasn't done, do it. Read the manual on how to do it.
