roweder

I have a muggy and i need a pipe, but i have no idea which way to go. I've had an lst2 since i was 12 (I turned 14 last week) and over the summer i turned it into a muggy because the muggy is 2 lbs lighter (not yet i still have aluminum shocks) and alot faster. i was wondering if any of you could tell me what kind of pipe would give me great torque + acceleration, with an increased top speed. I am using a Dynamite Mach 427 with a bump start backplate, I am going to have a Dynamite DPS21 carburetor, wich will have a 7.5mm restrictor. I already have a Nova RC cooling head, and an 8ight's clutch, and i always run 20% nitro.




^8ight's clutch


my dad's not the one who got me started in this, so asking him would be no use.

Thanks to any one who will help

NitroDemon18

A stock muggy pipe would be fine. If you can afford it get a Jammin JP3. Why do you have two threads on the same subject?

harrow

JP3!!!!!!!!!!!!!!!!!!!!!!

MiamizFinest

i too agree with the JP-3 i run the hard coated one in my mugen MBX5T prospec truggy and love it plus ive had it for about 6 months and it still looks liek the day i bought it the HARD COATING is AWSOME screw that chrome stuff the track eats it up!!!!


the only thing i have noticed tho is the JP3 pipes makes motors eat up a little more fuel than normal.........ive tested it out and the JP3 pipe kills about a minuet of run time.......but this was compared to a OS 2060 pipe i would if others have noticed this??

roweder

i have 2 on the same subject because no one responded to the other in like 3 days, so i made another, with a little less writing and... Bam! 3 replies in like 2 hours!

HerrSavage

How would the Tsais M32 compare to the JP3??

roweder

do you have a link to that pipe?

roweder

nevermind i found it in a-main
[link=http://www.amainhobbies.com/product_info.php/products_id/6255]Hard Anodized $62.99[/link]
[link=http://www.amainhobbies.com/product_info.php/products_id/6254]Polished $53.99[/link]

it looks sort of low capacity, do you get good torque [link=http://www.rcuniverse.com/community/profile.cfm?section=profile&forum=1&memid=202853]PatrickBW[/link]?

HerrSavage

I have the JP2 with Axial 28RR on my Muggy, but that Tsais M32 is supposed to be awesome.... I want something for more high end, so for me I think it's one of these....

Here's a short vid clip of a Losi 8T with it and a Ninja 28... Hot engine yeah, but the pipe obviously isn't bad...

http://www.myvideo.de/watch/2170276


ps EDIT - Having just watched that vid again, I think I'll go for the Tsais...(that was my Ninja too, but I sold it for a profit.... Dang....)

gasfreak

My Feedback: (13)

From where I am sitting those wheels and tire look to be off a LST 2 and will probably give real problems for the muggy

roweder

i know, i'm not keeping them, do you have a pipe recommendation?

gasfreak

My Feedback: (13)

Everyone says the jp 3 is the shizznit but have no first hand experience with it,I am kinda in the same boat so I will be looking at your post also.By the way that is a clean Muggy

roweder

really? you think so? thank you.