Fly Wheel/Piston stuck at top dead center?
#1
Senior Member
Thread Starter
Join Date: Jul 2008
Location: Highlands Ranch,
CO
Posts: 1,065
Likes: 0
Received 0 Likes
on
0 Posts
Fly Wheel/Piston stuck at top dead center?
My piston/fly wheel is stuck at top dead center. I can turn it with my shaft start, but not by hand. It was running fine one day and now this the next. I couldn't start it at all.
#2
Senior Member
Join Date: Apr 2007
Location: N, UNITED KINGDOM
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
RE: Fly Wheel/Piston stuck at top dead center?
If its a new engine then this might be normal, just needs breaking in, if not sounds like it might have run too lean and over heated
#3
Senior Member
Thread Starter
Join Date: Jul 2008
Location: Highlands Ranch,
CO
Posts: 1,065
Likes: 0
Received 0 Likes
on
0 Posts
RE: Fly Wheel/Piston stuck at top dead center?
Well, somehow the piston developed a nick in it and ruined the sleeve and piston. Now I'm going to get an LRP Spec 3! Any one know here I can get one cheapest or have one you would be willing to sell?