So Cal

The clutch in my muggy is SHOT, and im trying to sell it and a car that doesnt go anywhere is a bit hard to sell, so i went down and bought new bearings, and shoes and when i went to remove the springs the clutch shoes where so worn that the aluminum surrounded the sping and they are stuck in the shoe. I tried getting one out and the spring is trash now. My LHS in Hobby people and i am going to get XTM springs. My question is what size springs should i get? 1.0mm, 0.90mm, or 1.1mm? Thanks,
Aaron

full maxx

depends how you want it to react ...  90 will react quickly and 1.1 will take slightly higher rpms to grab

So Cal

Ok, thanks,