Case size measurements? (Full Version)

All Forums >> [Glow Engines, Gas Engines, Fuel & Mfg Support Forums] >> Engine Manufacturers Direct Support Forum >> Jett Engineering Support

Message

---

Flying Foot Doc -> Case size measurements? (8/17/2003 5:49:32 PM) HI, seriously considering a Jett engine to learn to fly fast before going to DF planes and engines. So this will go on a GP LearJet that was set up for a ST 51. It has about 33 -34 mm of crankcase width set in the mount, adjustable to some degree. Where can I find the case sizes and measurements? TIA, Andy Levy

---

bob27s -> Case size measurements? (8/18/2003 6:14:11 PM) Hi Andy, Thank you for writing..... Dimensions for all Jett engines can be found on the jettengineering.com web site in the Technical Specifications section. Here is a quick short cut http://www.jettengineering.com/tech/dimensions.html The crankcase width for a SJ46 or SJ50 is approximately 35 mm. Size and mounting dimensions are the same as an OS46. If you have any other questions, please feel free to post here or email me at [email]bob27s@hotmail.com[/email] Thanks for considering Jett engines for your project Bob Brassell

---

Page: [1] 1

SITE MAP!   : :   FORUM RULES © 2001 - 2007 24-7 RC, LLC, all rights reserved.

0.0625