Will this cause interference? (Full Version)

All Forums >> [Radios, Batteries, Clubhouse and more] >> RC Radios, Transmitters, Receivers, Servos, gyros



Message

canesugarrules -> Will this cause interference? (8/21/2003 4:18:43 AM)

I am building a Wattage Crazy Max (electric). It is a fairly tight fit in the fuselage, and the elevator and rudder servos are touching (HS-55). Will this cause any interference?

Thanks



Lynx -> Will this cause interference? (8/21/2003 9:52:17 AM)

Not very likley, as long as the control arms can't hit each other.



FLYBOY -> Will this cause interference? (8/21/2003 7:45:22 PM)

I have done that quite a bit. You shouldn't have a problem.



canesugarrules -> Will this cause interference? (8/22/2003 2:11:39 AM)

Thanks. Only the cases are touching. I'm going to range test anyway.



jchuston -> Will this cause interference? (8/22/2003 7:24:43 AM)

I own a Crazy Max (bought it in February of this year) and I think that this is standard for the servos to touch (at least for the Rudder/Elevator combination of servos...)

I am not using 55's, I am using 81's, but they will be fine...just be careful with how you locate the wing in the wing saddle, and make sure that you do a little sanding around the sharp edges of the saddle after you cut it down to size...I didn't have this problem, but I have heard of a couple of people losing their fuse from the wing because that sharp-edges plastic cut through the rubberbands that they were holding their wings on with...also, even though the plans call for 2 rubberbands on the wing...just use 4...better safe than sorry...

-John



canesugarrules -> Will this cause interference? (8/24/2003 11:09:52 PM)

Thanks



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.140625