Ziroli A-D1 Skyraider (Full Version)

All Forums >> [RC Airplanes] >> RC Warbirds and Warplanes



Message

mmaney -> Ziroli A-D1 Skyraider (10/28/2011 9:58 PM)

I have just gotten this plane at a swapmeet It is just the airframe. I am looking for informationon C\G servos, motor, retracts, and any other information you guys would be willing to share.
Thank You
Mike Maney



All Day Dan -> RE: Ziroli A-D1 Skyraider (10/28/2011 10:59 PM)

Mike, use this website for the CG if no one knows any better. Put it at the 28 percent point. Dan.
http://www.geistware.com/rcmodeling/cg_calc.htm#mac



STUKA BARRY -> RE: Ziroli A-D1 Skyraider (10/29/2011 1:04 AM)


quote:

ORIGINAL: mmaney

I have just gotten this plane at a swapmeet It is just the airframe. I am looking for informationon C\G servos, motor, retracts, and any other information you guys would be willing to share.
Thank You
Mike Maney

Excellent flying aircraft. Although Nick designed it for the G-62, I'd put a Quadra 75, DA85, Taurus 72, or anything close for power. Robart retracts are the norm, but Sierra retracts from Darrell are the best. Dont go crazy with servos, any 50 in. oz. servo will be just fine. The plane plane should weigh around 32lbs. There are plenty of "Sandys" out there if your not quite sure on a paint scheme. Good-Luck with it.



leadgofer -> RE: Ziroli A-D1 Skyraider (10/31/2011 2:24 PM)

Quadra 75M, Robart retracts, 80+ oz. servos on the flaps & elevators. No weight needed to balance with this set up.



ROGER RUSSELL -> RE: Ziroli A-D1 Skyraider (10/31/2011 2:42 PM)

Another pic of leadgofer plane



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

RC Universe is a service of Internet Brands, Inc. Copyright © 2001-2013.
9.301758E-02