Well i got my plane a few weeks ago.  Yea! It was an ARF model.  Some of the servo wire were a little short.  I took it out to the airfield and thought I would taxi for a bit, just to get my nerves up.  When I put the batt in, everything worked but the motor. After some testing, I found the ESC was bad. I had to go back home to steal an Eagle 60 ESC from another plane.  Well I started a low speed creeping taxi. Down the street then while turning to come back, i rolled over a center line reflector in the road. The landing gear popped out of the wing and the plane bellied the ground. Three blades of the prop broke. So the decision to go with two or four bladed prop was made for me. After re-alighning the landing gear and gluing them back in place, I put an Airscrew prop on it and took off with half flaps. The plane wants to fly quickly and gets in the air fast. Mine kept tipping the left wing even with  full trim on the alerons and some on the rudder. I think a weight issue. Be warned, Its not a speedster in the sky.  Landings require attention. Hint, keep some power going. The Plane will settle and float down.  The down side is that is can porpus on you and once on the ground, you have very little steering until the tail slow down quite a bit.  make sure the runway is clear ahead of you and stay on center line.

On my last flight, my rollout was too fast and too long in a small parking lot. Now I am in need of one main landing gear. Left side.  Anyone know where I get one?

Thanks and happy landings