swash ball help needed ..Please!!!!! (Full Version)

All Forums >> [RC Helicopters] >> Electric RC Helis



Message

telemark07 -> swash ball help needed ..Please!!!!! (8/27/2003 6:43:50 AM)

Just got all my mods and goodies from the US and included in that was a swash ball.

I had better clear up some assumption that I have first.
The swash ball goes on the under side of the swash plate? yes...

it should fit closlt with the top of the swash plate as possible? yes?

The swashball that I have and the small balck housing tht it comes in does not fit into the inside of the swashplate assembly.

what am I doing wrong......


here are some pics of the parts.
(God I love the t610!!)



avance_x -> swash ball help needed ..Please!!!!! (8/27/2003 10:37:57 AM)

Have you check this ?



telemark07 -> swash ball help needed ..Please!!!!! (8/27/2003 10:48:01 AM)

YES!!!!!!!!!! this is the missing bit of information that I needed ....Thanks mate

tele



bikerdude -> RE: swash ball help needed ..Please!!!!! (9/9/2003 10:57:10 PM)

Hi mate i have the same problem but i have the skylark is this true that i should fit this part to the underside of the swashplate so it fits into ball bearing part because i just dont know please help.



avance_x -> RE: swash ball help needed ..Please!!!!! (9/10/2003 12:05:06 AM)

quote:

ORIGINAL: bikerdude

Hi mate i have the same problem but i have the skylark is this true that i should fit this part to the underside of the swashplate so it fits into ball bearing part because i just dont know please help.



Installation should be on the top and not on the underside. Make the center of the ball links (of the swash plate, both inner and outer swash) as the reference imaginary center line.
Ideally the centerline of the outer and the inner swash ball link as well as the swash ball (mod) should be on a common plane.

Hope this helps!



Hoverup -> RE: swash ball help needed ..Please!!!!! (9/10/2003 3:43:17 AM)

.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.171875