belt cp servo question (Full Version)

All Forums >> [RC Helicopters] >> Electric RC Helis >> Esky Helicopters



Message


bob40 -> belt cp servo question (2/13/2012 10:42 PM)

i crashed my belt cp and had to install a new pitch servo.Before fully installing it i plug it in and it went all the way to the left and then kept vibrating.I tried that a couple of times but don't want to burn it out.There is no response when i give it throttle.Any ideas? Also it is an esky servo.




aircrash -> RE: belt cp servo question (2/15/2012 6:51 PM)

Most  probably you got either a fake or a bad one. Most, if not all, Esky servos sold at ebay are fake and bad quality.
Just plug one of the other servos you have in this channel to the receiver and see if the receiver is not damaged.
If it is not, which it must not be, then you definitely got a fake or bad one.





bob40 -> RE: belt cp servo question (2/16/2012 12:04 PM)

Thanks i will try that.I did buy it from a reputable company but who knows..




jester_s1 -> RE: belt cp servo question (10/5/2012 4:42 AM)

Even if it's a real Esky servo, they aren't that good to start with. If you'll put a few dollars into better servos it makes a big difference in how well the machine flies, at least in mine it did.




Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

RC Universe is a service of Internet Brands, Inc. Copyright © 2001-2013.
0.046875