*** 1/8 Esc & motor for D8te *** (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> RC Electric Off-Road Trucks, Buggies, Truggies and more



Message

k20_94_dc -> *** 1/8 Esc & motor for D8te *** (2/14/2012 8:27 PM)

OK I'm not to sure where to start. I've got a mmp esc and I'm looking to get a 1/8 scale truggy so I'll be in the market for a esc and motor My 1st question is would the Mmp handle the 1/8 motors? CC 2200kv 2650kv 2nd. What would be a good reasonably priced motor to get and what kv should I look at? Also what battey type 2s 3s etc. I'm wanting to get a hot bodies d8t converted to electric with the tekno kit. Thanks everyone



k20_94_dc -> RE: *** 1/8 Esc & motor for D8te *** (2/15/2012 4:16 AM)

Any input?



cummins driver -> RE: *** 1/8 Esc & motor for D8te *** (2/15/2012 2:21 PM)

Yes, the MMP will handle 1/8 scale motors and you can go up to 4s with it. You wouldnt want to run any less than 3s in a truggy, but id say 4s would be about perfect. Thats what i would run. Running the higher voltage also keep the amp draw down.

This motor would probably suit you very well if you are looking at something on a budget:

http://www.hobbypartz.com/96m218-4465-1800kv-11t.html

There are lots of other good motors that will work. Just stay around 2000kv in a truggy with a 36-44mm can size and 65-74mm length.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

RC Universe is a service of Internet Brands, Inc. Copyright © 2001-2013.
0.125