Setting end points on tornado epx pro? (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> Redcat Racing Support



Message

aitrus1 -> Setting end points on tornado epx pro? (9/4/2012 7:22 PM)

Ok I recently replaced the steering servo in my tornado epx pro after the stock one broke, but now it won't turn very far in either direction. I can't really think of a reason for this unless the end points for the servo need to be adjusted? Can you even do that with this car? Any help would be appreciated, thanks



nitrosportsandrunner -> RE: Setting end points on tornado epx pro? (9/4/2012 7:36 PM)

it could be the steering duel rate adjustment on your radio.
its the nob on the right hand side. Make sure its turned all the way up. If its turned down, you will have limited steering.

also, when you put the servo on did you power up the car and center the steering trim (on radio) before you put on the servo horn (linkage)?



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

RC Universe is a service of Internet Brands, Inc. Copyright © 2001-2013.
0.03125