ofna x1 crt (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> RC Truggy



Message

doug702 -> ofna x1 crt (10/8/2012 7:37 PM)

i just got a very nice used ofna x1 crt, not sure of pro or rtr version. all i know is that when i put in my sh.28 motor the backplate/pullstart causes the engine to tilt foward. is there a set of mounts to fix this? do i have to run a motor with no pullstart? are there differences in the chassis between rtr and pro version?



doug702 -> RE: ofna x1 crt (10/8/2012 8:38 PM)

any help/info will be appreciated



doug702 -> RE: ofna x1 crt (10/8/2012 11:01 PM)

anyone selling a starterbox, i think im just gonna change the motor to non ps

hope its ok to ask for items in here



Anthoop -> RE: ofna x1 crt (10/11/2012 6:43 PM)

You could raise the engine or the mounts using flat washers...always ensure the screws are long enough to provide a reasonable amount of thread engagement.



doug702 -> RE: ofna x1 crt (10/11/2012 6:59 PM)

i tried that and now the engine is to close even at its farthest point away from the spur gear. i could open up the engine mounting oles on the chassis but that is not something i really want to do.
 thanks for the tip though.



Anthoop -> RE: ofna x1 crt (10/11/2012 7:57 PM)

Possible to file some material from the bottom of the pullstart/backplate?
What size pinion are you using?



doug702 -> RE: ofna x1 crt (10/11/2012 8:13 PM)

id like to use a 16 or 17 tooth bell. ill try and file off the bottom of the pull start thanks. that just might work



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

RC Universe is a service of Internet Brands, Inc. Copyright © 2001-2013.
0.0625