|
a70eliminator -> Saito twin Flex pipe pressue tap for smoke (11/17/2012 6:54 PM)
|
Hi guys, I've got my 300T on the test stand trying to make smoke without using a pump. I set up a second pressure tap off the left pipe same location identical to the factory installed one on the right, I then brazed in my nozzles right close to the manifold. I'm using the dubro system that comes with the check valve and shut-off valve, I have it all plumbed in as directions but cannot get fluid to flow from tank.
I'm thinking that the flex pipe isn't allowing enough of a pressure difference between the head pipe and where the pressure tap is, being that the entire pipe is pretty close to the same diameter beginning to end, other than the cuff where the pressure taps are attached, anyone ever get smoke pressure off the flex pipes to work? I may have to just break down and get a and pump but I'm not giving up easily on this.
|
|
|
|
