Carson receiver pinout (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> RC Car General Discussions



Message

blyfod -> Carson receiver pinout (11/23/2012 10:15 PM)

 I have this Carson receiver and need to know which pins mst be connected for Battery.
As you see there are 6 x 3 pins, but which ones (two) are ground and plus?





Lars from Norway -> RE: Carson receiver pinout (11/23/2012 11:05 PM)

Use the "batt."-pins to power it up, but if you are using it together with an ESC this will power it through the servowires.



Big Alice -> RE: Carson receiver pinout (11/23/2012 11:26 PM)

http://www.carson-modelsport.com/CommonFiles/Dickie-Tamiya/PDM_Products/Carson/500500033/500500033_Bedienanleitung.pdf

   This is for a 3 chanel carson radio. The pin orientation should be the same. Page 21  Black wire is on the outside.



blyfod -> RE: Carson receiver pinout (11/24/2012 11:43 AM)

Must have expressed myself badly. Let's try again:

There are 6 channel sets of 3 pins, AND there is a set for BATT, which also have 3 pins. 
I just need to know which 2 of these 3 pins I must connect power to. The connector to this receiver has 2 pins, so it is important to connect it correctly. I suppose that ground is towards the edge of the unit (???)

  



Big Alice -> RE: Carson receiver pinout (11/24/2012 4:54 PM)

[IMG]http://i127.photobucket.com/albums/p130/Budman_222/carsonreceiver.jpg[/IMG]

 



blyfod -> RE: Carson receiver pinout (11/24/2012 11:49 PM)

Thank you very much Big Alice  



Lars from Norway -> RE: Carson receiver pinout (11/25/2012 10:49 PM)

Lol, i suddenly realized what your nickname means; lead foot[:D]



blyfod -> RE: Carson receiver pinout (11/30/2012 11:41 PM)

That's right.
I referring to my driving  



Lars from Norway -> RE: Carson receiver pinout (12/2/2012 12:04 AM)

I thought so[:)]



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

RC Universe is a service of Internet Brands, Inc. Copyright © 2001-2013.
0.1171875