Hello all,

 

After a couple years off of flying I decided to get back into it, and finish some unfinished projects. On the top of the list is to install this camo TTMD500 body collecting dust, onto my raptor 70 with the 90 tailboom kit.
I've run into a problem. Step 9 of the manual says that there are impressions on the bottom of the canopy where I am suppose to trim away to fit the rubber grommets around and slide the struts through. But...of course I seem to have gotten the Kit which does not have any markings at all that shows where to trim or evern begin.

 

Can anyone that has done this build, send some help my way? Tips, pictures, and especially measurments would be great..the know how, so that I can make sure I am placing these holes and the struts in the correct positions before I cut.

 

I would REALLY appeciated it.

 

Sincerely,
Christopher