I need tmaxx help (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> RC Monster Trucks >> Traxxas Monster Truck forum

Message

---

pamaxxposse -> I need tmaxx help (10/15/2003 11:09:06 PM) I just completely put my engine back together and am sure i tightened everything. After about 10 minutes, I noticed oil on my exhaust pipe again. How did it get there. Is there a small hole in my fuel line or is it coming from my carb?

---

jval144 -> RE: I need tmaxx help (10/15/2003 11:45:02 PM) check your fuel lines look for a pin hole

---

frambo -> RE: I need tmaxx help (10/16/2003 5:21:56 AM) is it on the pipe or on the header? if it is on the header, check your header gasket for a leak...

---

j-maxx -> RE: I need tmaxx help (10/16/2003 10:18:21 PM) yea check u lines ur header gasket and did u put the copper or brass gasket in between the engine case and the cooling head

---

pamaxxposse -> RE: I need tmaxx help (10/17/2003 11:39:50 PM) I just retightened the header before this. How would i check for a pin hole in my fuel line if i can't see it with my eyes?

---

Tigger N. Bennie -> RE: I need tmaxx help (10/17/2003 11:58:04 PM) Blow through it like you would a straw or just replace it. While you are at it you might as well check the fuel tank and fuel cap for air leaks. The cap has an o-ring under it that can be tightened. Some of the older fuel tanks also have a primer which is known for air leaks--I guess that is probably one reason Traxxas replaced it on the latter T-Maxx 2.5s.

---

Mr. RCGuy -> RE: I need tmaxx help (10/18/2003 12:25:10 AM) Just a suggestion clip off the zip ties on rubber coupler and install new zipties and cinch them down very tight

---

Page: [1] 1

SITE MAP!   : :   FORUM RULES © 2001 - 2007 24-7 RC, LLC, all rights reserved.

0.140625