electric PBF (Full Version)

All Forums >> [Electric Aircraft Universe] >> 3D Electric Flying!



Message

PBF/MAXXER -> electric PBF (11/9/2003 1:51 AM)

i curently have a nitro PBF with a GP .42 engine that died. I would like to convert it to an electric.

What motor and ESC should i use??[8|]



flip3d -> RE: electric PBF (11/10/2003 4:59 AM)

ok here we go.
i have gone threw 7 or 8 different sizes and material but the best is fan fold foam and same size as the gass one (24x24)
a gws 350 with d gearing. a gws 12x6 prop
15 esc.
2 cell lipo or 8 or 9 cell aaa nimd
little recever.
i may be able to kit some for like 6 bucks. but only if i get enuf intrest.

philip



ksflyer-RCU -> RE: electric PBF (11/17/2003 6:44 AM)

Have built many out of blue fanfold, depron, pealed foam board, etc. A GWS IPS motor and two or three lipoly's along with a piece of foam about 16" or 18" seems to be a good size. Building them with a airplane profile body works well as well. Add a rudder if you want to do any hovering.

KsFlyer
Av8 Hobbies.com



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

RC Universe is a service of Internet Brands, Inc. Copyright © 2001-2012.
0.046875