Glow carb to run gas conversion? (Full Version)

All Forums >> [Glow Engines, Gas Engines, Fuel & Mfg Support Forums] >> RC Fuels



Message

Eagle Flyer -> Glow carb to run gas conversion? (5/9/2002 7:32:52 AM)

Does anybody know of someone who can properly do the needed work to convert a glow carb to run gas? As I understand it the needles have to be retapered to a much sharper angle as do the seats to give a much more sensitive adjustment to match the smaller fuel flow requirements. I would rather stay with the basic factory carb and redesign it internaly to accomplish a straight replacement. The intended engine is a Saito 180. Any info would be greatly appreciated. Thanks; Jim



rsieminski -> Glow carb to run gas conversion? (5/9/2002 9:41:47 AM)

I don't know who can do the work, but I was lookinginto this not too long ago. Here's the link for ProSpark® Electronic Ignition Systems, from nelson hobbies. They might know: http://www.nelsonhobby.com/ignition/ignition.html
--Rick



Elwood -> Glow carb to run gas conversion? (5/9/2002 5:05:00 PM)

You might get more responses in the Engines Forum...



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.15625