| ||||||||||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Old Question: New Engine Break In
View related threads: (in this forum | in all forums) |
Logged in as Guest
     
|
|
 Printable Version
|
|
||||
|
| ||||
All Forums >> RC Cars, Buggies, Trucks, Tanks and more >> RC Car Engines >> Car Nitro & Gas Engines >> Old Question: New Engine Break In
|
|||
|
|||||||||||||
Old Question: New Engine Break In - 
Okay, I know this is probably a well beaten topic, but I have had no luck finding it. I have a NEW .15 
|
|||||||||||||
RE: Old Question: New Engine Break In - 
Just let the engine idle rich for 2 tanks(wheels off the ground), drive around going from idle to 1/4 throttle on tank 3, 1/2 on tank 4, 3/4 on tank5, and briefly to full on tank 6, let the engine cool for 10 min in between tanks, on tank 7 start leaning the HSN 1/8 of a turn at a time till you get some good power, make sure you do a few laps in between adjustments. When the hsn is tuned properly , you should be able to hold WOT and the engine should not bog , next tune the LSN by pinching the fuel line near the carb, if the engine dies within 3-5 seconds your good, less than3 is too lean and more than 5 is too rich, a good temp range is 220F-250F
|
| All Forums >> RC Cars, Buggies, Trucks, Tanks and more >> RC Car Engines >> Car Nitro & Gas Engines >> Old Question: New Engine Break In | ||
| Page: [1] |
||
|
|
||
|
| ||