Faskolor airbrushing problem (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> RC Painting, Detailing & Bodies



Message

DirtLip -> Faskolor airbrushing problem (11/18/2004 9:46 AM)

Hi everyone. The problem is when i spray faskolors thru my iwata sbs, it spits out pretty bad, no matter how much the paint is thinned. The weird thing is that water and my spaz stiks paints spray fine. Ive tried almost every psi I can, checked for water in the hose and everything. Is it possible I need a bigger size needle and nozzle? I believe it came with a .35. Please help

later,
dirt



niffken -> RE: Faskolor airbrushing problem (11/18/2004 4:04 PM)

jack up the PSI or keep thinning.



fireguy01 -> RE: Faskolor airbrushing problem (11/20/2004 2:52 AM)

yeah that has happened to me before. but i think it was due to the paint sitting around for a while. actually i stopped using it as a result. then i found spaz stix THE BEST ! or pactra has acrylics that i prefer to faskolor. but i know local guys that swear by it and some of the work they do with it is awesome. maybe it is more of a problem with the airbrush than the paint. i dunno.



69 GTO -> RE: Faskolor airbrushing problem (11/20/2004 7:25 AM)

I have had the same problem. I've found that faskolors spray better at a much higher psi than any other paint, i usually bump mine up to about 60 psi when i use it. Also thin it down a bit more than other paints.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.09375