RE: Walkera DragonFly #35 CCPM Electric RC Helicopter Reviews  
View related threads: (in this forum | in all forums)

Tower Hobbies
Enter up to 4 keywords or Tower stock numbers
Logged in as Guest



Users viewing this topic: none
  Printable Version
       


Align T-REX 450SA ARF
Seller:  Erick Royer
Details:   $150.00   |  8/27/2008   |  Classified Ad
We will rotate YOUR AD in this spot if you select "Forum Featured" when placing or editing your ad!

All Forums >> RC Helicopters >> Electric RC Helis >> Walkera Helis - Dragonfly, etc.. >> RE: Walkera DragonFly #35 CCPM Electric RC Helicopter Reviews
Page: <<   < prev  47 48 49 50 51 52 53 [54] 55 56   next >   >>  

Login
Message << Older Topic   Newer Topic >>
RE: Walkera DragonFly #35 CCPM Electric RC H... - 3/31/2006 9:24:30 PM   
kk23


 

Posts: 8
Joined: 1/24/2006
From: , BC, CANADA
Status: offline 		I CANT GET MY MAIN ROTORS TO EVEN SPIN...i jus got the thing and i cant get the main rotors to do anything at all....can anyone help? its a walkera 35

(in reply to TDubya)
       Post #: 1326

RE: Walkera DragonFly #35 CCPM Electric RC H... - 3/31/2006 11:42:32 PM   
kk23


 

Posts: 8
Joined: 1/24/2006
From: , BC, CANADA
Status: offline
ok nevermind.....i got the rotors to turn but it looses contact with the t.x sometimes and does w.e it wants. could this have somthin to do with the low tx batteries or the antenna not properly ran.. cause right now my antenna is wrapped around the skids....should it be out the back in a tube??

(in reply to kk23)
       Post #: 1327

RE: Walkera DragonFly #35 CCPM Electric RC ... - 4/3/2006 8:21:42 AM   
fosterk


 

Posts: 21
Joined: 2/7/2006
From: AucklandAuckland, NEW ZEALAND
Status: offline 		Mine ran fine with the anttena on the skid. On one occasion when I first got it, was running it up in my lounge and it seemed to loose cotact with the transmitter and went crazy (resulting in loosing my first tail gear, shaft and tail blade carrier) and had to stop it by pulling the plug, otherwise it was fine. These things seem to be notorious for dodgy electronics though.

_____________________________

Currently in The garge: Hobao GPX4, Tamiyas
The hanger: Walkera 35, slopies, + 2 new balsa projects

(in reply to kk23)
       Post #: 1328

RE: Walkera DragonFly #35 CCPM Electric RC ... - 4/4/2006 3:09:28 AM   
hanney


 

Posts: 191
Joined: 9/2/2005
From: babylon, NY, USA
Status: offline 		hi, i got all new servos uin hy heli, and now ican only get it just to have the heli to dance, but then it just dies, i think that the problem is the battery, what battery shuld i get to get flight time out of my heli?

_____________________________

http://www.defensereview.com/stories/aa-12/AutoCopter_Gunship.mpg
my 2 most fav thing guns and rc

(in reply to fosterk)
       Post #: 1329

RE: Walkera DragonFly #35 CCPM Electric RC ... - 4/4/2006 3:26:37 PM   
nail-pounder


 

Posts: 124
Joined: 11/12/2005
From: Carmel, CA, USA
Status: offline
quote:

ORIGINAL: hanney

hi, i got all new servos uin hy heli, and now ican only get it just to have the heli to dance, but then it just dies, i think that the problem is the battery, what battery shuld i get to get flight time out of my heli?


Get a 2200mAh 15C

(in reply to hanney)
       Post #: 1330

RE: Walkera DragonFly #35 CCPM Electric RC ... - 4/5/2006 1:53:08 AM   
NVSFlyer


 

Posts: 137
Joined: 1/30/2006
From: West Jordan, UT, USA
Status: offline 		Hanney 12c or above and for longer flight a 1500mAh or above. The 12c will have plenty of Amps to spin your motor even at 12c 1500mAh gives you a continous 18 Amps which is plenty for the 35. I run 12c 2200mAh and get almost 18mins of hover time on mine. Good luck

(in reply to hanney)
       Post #: 1331

RE: Walkera DragonFly #35 CCPM Electric RC ... - 4/6/2006 1:44:39 AM   
iamnew


 

Posts: 3
Joined: 4/6/2006
From: , MI, USA
Status: offline 		Hello. i am new at the mini heli thing . just got the wakera dragonfly #36. watched battery charge, plug into heli test servos (all work) , but the blades don't spin. it just beeps, and has a constant red light on gyro. the light blinks when i move the servos, but can't get to "start". i checked to see if stuck or tight , but spin loose, just no power?

sorry if bit mumbly, but work all day come home to try new toy and just watch the servos move back and forth, sad.


lipo batt 1800mah (2), brushless, train kit(how it goes on i dunno), extra blades.

(in reply to NVSFlyer)
       Post #: 1332

RE: Walkera DragonFly #35 CCPM Electric RC ... - 4/6/2006 3:14:19 AM   
nail-pounder


 

Posts: 124
Joined: 11/12/2005
From: Carmel, CA, USA
Status: offline 		iamnew, Does the receiver light flash or is it on steady? It should be on steady. If it is flashing, it means the receiver (rx) is not receiving a signal from the transmitter (tx). Chech that your transmitter is on. The bar scale on the tx should light all the way to green. You might have to move the rx antenna wire to get a better reception. Try to keep it away from other wires. They can cause interference with the radio. Check your motor connections. Also FYI, there is another thread that deals with the 36 exclusively. (Walkera #36) It is a long thread, 157 pages at present. Scan through the pages from page 1. Along the way you will find some detailed setup procedures. The heli needs to be set up properly before you begin to think of flying it. It is very important. Don't skip it. The radio as well as the mechanics of the heli need to be set up properly.

Al

(in reply to iamnew)
       Post #: 1333

RE: Walkera DragonFly #35 CCPM Electric RC ... - 4/6/2006 3:21:15 AM   
nail-pounder


 

Posts: 124
Joined: 11/12/2005
From: Carmel, CA, USA
Status: offline 		iamnew, Another thought, you note that you have a brushless motor. That means you have an electronic speed controller. (ESC) Has the esc been programmed yet? It might have to go through a programming phase before it will send power to the motor.

Al

(in reply to iamnew)
       Post #: 1334

RE: Walkera DragonFly #35 CCPM Electric RC ... - 4/6/2006 3:23:56 AM   
iamnew


 

Posts: 3
Joined: 4/6/2006
From: , MI, USA
Status: offline 		loosesned motor from main gear, spin up. but when i tried to get it to just hover a few inches one of the control arms (automotive term yes but same thing) came loose went side ways and broke a blade and stripped the gear.

sorry.... it was ready fine just gear too tight as mentioned above ( up in page not my post, must have over looked).

so now i order a gear and control arm linkage thing. do they make them in cnc aluminum for this heli? that would be the way to go.

ps even though it crashed, not entirly my fault, it was fun to hear it scream!

(in reply to nail-pounder)
       Post #: 1335

RE: Walkera DragonFly #35 CCPM Electric RC ... - 4/23/2006 4:48:59 PM   
hanney


 

Posts: 191
Joined: 9/2/2005
From: babylon, NY, USA
Status: offline 		is there any aftermarket bodies that i can get? lik a full body? lik the bell 222? thanks alot
and i want to get a brushless, what shuld i get


_____________________________

http://www.defensereview.com/stories/aa-12/AutoCopter_Gunship.mpg
my 2 most fav thing guns and rc

(in reply to iamnew)
       Post #: 1336

RE: Walkera DragonFly #35 CCPM Electric RC ... - 4/23/2006 5:57:08 PM   
nail-pounder


 

Posts: 124
Joined: 11/12/2005
From: Carmel, CA, USA
Status: offline
quote:

ORIGINAL: hanney

is there any aftermarket bodies that i can get? lik a full body? lik the bell 222? thanks alot
and i want to get a brushless, what shuld i get



Hanney, here's a link for bodies: http://darthdrk.4t.com/

I have an Align 430L & 35A ESC combo from http://www.readyheli.com/ $99.00 inc. shipping.

Al

(in reply to hanney)
       Post #: 1337

RE: Walkera DragonFly #35 CCPM Electric RC Helicopter R... - 5/1/2006 4:50:02 AM   
cdavis35


 

Posts: 1
Joined: 5/1/2006
From: okc, OK, USA
Status: offline 		i just bought a dragonfly 35. my second heli and cant even figure out how the battery connects to it. there are three connections and my li. po. battery only has one that fits. there is a connection that came with it so i hooked it up how i thougt it should go and when i turned it on the blade just started going with the throttle all the way down. could someone help me out?

(in reply to neweheliflyer)
       Post #: 1338

RE: Walkera DragonFly #35 CCPM Electric RC Helicopter R... - 5/1/2006 5:27:05 AM