Scoubidou
Posts: 1566
Joined: 7/7/2003 From: Boisbriand,
QC, CANADA Status: offline
|
quote:
WHen I first tached it...it was showing 5800 - 5900. We have since leaned it up a little...as it was kind of gurgling in flight. I have not tached it since...we were also using a cheap tach...I have the one that plugs into the ignition..but could not get it to work...it kills the engine everytime it is plugged in. Sending it back to get repaired or replaced. It has definitely picked up some RPM's though since we adjusted the needles some along with the little break in time that has accumulated so far. The temp has been reading around 200 - 210 right after shut down. 5900 RPM seems very low. Here is what I have tacked on my super ZDZ-80 on KS-95 can: NX 27x10 5900 RPM, did not like it noisy, no vertical, no power, it's for sale 25$ Mejzlik 26x10, 6800 , good for 3D Biela 26x10 6400-6500 Perfect prop for IMAC/3D. I found the super ZDZ is happy to turn over 6500 RPM. There are 2 buttons on the ZDZ tach: -one convert RPM to a bar graph -the other kills the engine to display the maximum RPM reached in flight. Daniel
_____________________________
Seneca Engineering http://www.seneca.ca/
|