RE: Official AFPD PPS variable pitch prop support thread

RE: Official AFPD PPS variable pitch prop support thread
View related threads: (in this forum | in all forums)

Logged in as Guest

Users viewing this topic: none

Printable Version

All Forums >> RC Airplanes >> RC Flight Simulator Software >> Ikarus AeroFly Pro and Aerofly Pro Deluxe >> RE: Official AFPD PPS variable pitch prop support thread Page: << < prev 1 [2]

Login

Message

<< Older Topic Newer Topic >>

RE: Official AFPD PPS variable pitch prop support thread - 5/31/2005 12:19:22 PM

Greg.B

Posts: 683
Joined: 4/17/2005
From: Huntingdon,Cambridgeshire, UNITED KINGDOM
Status: offline

Stew,

Have you checked the engine channel moves fully both ways when you turn the knob or flick the switch on your Tx?

Sorry Brett I haven't any ideas. It seems that everyone's gone deaf!

Greg.

(in reply to FreeFlier)

Post #: 26

RE: Official AFPD PPS variable pitch prop support thread - 5/31/2005 12:37:06 PM

Yogi149

Posts: 25
Joined: 3/17/2005
From: AachenNRW, GERMANY
Status: offline

Hi
for PPS you have to separate the controls.
I use slider for throttle on channel 20 in AFPD
and an stick on channel 0 for Pitch.
Stick in the middle will cause zero pitch.

_____________________________

greets Juergen Behrens
(yogi149)

(in reply to Greg.B)

Post #: 27

RE: Official AFPD PPS variable pitch prop support thread - 5/31/2005 7:06:29 PM

Icebird

Posts: 400
Joined: 1/7/2002
From: Calgary, AB, CANADA
Status: offline

quote:

ORIGINAL: Yogi149

Hi
for PPS you have to separate the controls.
I use slider for throttle on channel 20 in AFPD
and an stick on channel 0 for Pitch.
Stick in the middle will cause zero pitch.

Umm, I don't think so! I simply installed the patch, then the shocky, and it works just off my throttle stick. The motor is set up to run at a fixed speed, and the throttle controls the pitch. I don't know how to solve the problems others are having, but mine worked great right from the start.

I assume the guys that are having problems installed the patch before they installed the shocky and other PPS planes???

Jim

_____________________________

Of course I'm an expert!
X is an unknown quantity, and Spurt is a drip under pressure!

(in reply to Yogi149)

Post #: 28

RE: Official AFPD PPS variable pitch prop support thread - 6/1/2005 1:17:05 AM

8KCABrett

Posts: 251
Joined: 1/5/2003
From: Davis, CA, USA
Status: offline

"I assume the guys that are having problems installed the patch before they installed the shocky and other PPS planes??? "

Yep, if I patch it then I can't plug in the USB cord without the error. . . shocky or no shocky. I can load to the main menu if I unplug the USB cord, but as soon as I plug it in and press search the error pops up. I have heard of a few other people with the same problem, none of them have gotten a reply yet.

STLPilot is online now. . . I will check back in a bit.

_____________________________

-Brett
Northern California Aerobatic Club:http://www.iac38.org/

(in reply to Icebird)

Post #: 29

RE: Official AFPD PPS variable pitch prop support thread - 6/1/2005 3:31:42 AM

FreeFlier

Posts: 46
Joined: 8/21/2003
From: Long Island's North Shore, NY, USA
Status: offline

Thanks to Greg, Juergen, and Jim for your replys and suggestions. Juergen got it right, at least for my set up. I set line 20 "engine" to "not assigned" - or as he put it: channel 0. This solved the problem and gave me both backward and forward movement as the PPS addon intended. Why this works is a mystery to me, but it might help someone else with the same TX - Hitec Prism 7X.

One other interesting thing appeared since I made the setting change: now, by moving the mouse one way or the other the constant motor speed increases or decreases, thereby making the PPS model move faster or slower. I'm fairly certain this was not the case before, and just adds to the general enigma.

I was shocked when I saw the result of this setting change as I had assumed that the "engine" on line 20 was related to helis as it is with the other heli settings. But apparently this is not so. Then why have 4 "engine" settings on the first 4 lines and another down on line 20, and how are they related to the sim and to each other?

Well, enough simple-minded questions - the blooming thing works!, and at least this part of the world is right again.

Stew

(in reply to 8KCABrett)

Post #: 30

RE: Official AFPD PPS variable pitch prop support thread - 6/2/2005 4:18:55 AM

STLPilot

Posts: 9222
Joined: 3/12/2003
From: Manhattan, NY, USA
Status: offline

Guys I don't know what the problem is but I'll find out. It works fine on all my computers so I have not seen any issues.

But just note that this is a beta and they must have put a revert to previous version for a reason. This usually means they have had glitches. This is from IPACS website.

The files and downloads in this section are BETA version. They have therefore not been tested thoroughly or are only in an experimental state and might still contain bugs. Use the files from this page on your own risk.

There is another forum at IPACS website which they moderate ... not as often as we do, but they are more close niched with IPACS direct. Sorry but my support experience is limited to only what I know from my current database and what I have seen. The programmers know what I don't know on the inside.

Anyhow report bugs here: http://www.ipacs.de/cgi-bin/ultimatebb.cgi

< Message edited by STLPilot -- 6/2/2005 4:21:55 AM >

_____________________________

Here At The Wall

(in reply to Yogi149)

Post #: 31

RE: Official AFPD PPS variable pitch prop support thread - 6/2/2005 5:42:41 AM

8KCABrett

Posts: 251
Joined: 1/5/2003
From: Davis, CA, USA
Status: offline

Thanks for the reply, I guess wait for the final version and hope this is sorted out. . .whatever it is.

< Message edited by 8KCABrett -- 6/2/2005 9:00:57 AM >

_____________________________

-Brett
Northern California Aerobatic Club:http://www.iac38.org/

(in reply to STLPilot)

Post #: 32

RE: Official AFPD PPS variable pitch prop support thread - 6/2/2005 11:23:14 AM

STLPilot

Posts: 9222
Joined: 3/12/2003
From: Manhattan, NY, USA
Status: offline

If you want to help ... you'll report your bugs. That's what a beta version is ... they are basically asking for anyone to report them. This is common in all of software.

Report them on IPACS forum please. They can't fix what they don't know.

Make sure you post you computer specs.

< Message edited by STLPilot -- 6/2/2005 11:25:13 AM >

_____________________________

Here At The Wall

(in reply to 8KCABrett)

Post #: 33

RE: Official AFPD PPS variable pitch prop support thread - 6/2/2005 5:31:08 PM

_stinky_

Posts: 58
Joined: 4/24/2005
From: Haifa, ISRAEL
Status: offline

he he...
that happened to me too!
i downloaded the PPS, and it worked fine.
i tried it out..it was great!
but, then, out of the blue it stopped working.
when i push backward the plane doesn't respond at-all and it does crazy "slow-motion" moves.
and i can't control, than it comes back to the ground and crashes.
so PPS doesn't work for me either :\

(in reply to STLPilot)

Post #: 34

RE: Official AFPD PPS variable pitch prop support thread - 6/3/2005 4:34:13 AM

flyboy91

Posts: 497
Joined: 2/22/2002
From: monroe, MI, USA
Status: offline

I had the same problem where I didnt get as much backwards so what i did was went in and added another cell making it a 4cell lipo pack and everything is working great for me.

Andrew Jesky

PS I cant seem to find out where to get the slow ride.

(in reply to _stinky_)

Post #: 35

RE: Official AFPD PPS variable pitch prop support thread - 6/19/2005 2:05:30 AM

teamsme

Posts: 17
Joined: 1/27/2005
From: Baltimore , MD, USA
Status: offline

I'm having a problem, if I up the voltage on the pack, after about 10 minutes of flying
and when it crashes I lose more and more rpm at each extreme?

< Message edited by teamsme -- 6/19/2005 2:07:44 AM >

(in reply to flyboy91)

Post #: 36

RE: Official AFPD PPS variable pitch prop support thread - 7/5/2005 5:30:01 AM

8KCABrett

Posts: 251
Joined: 1/5/2003
From: Davis, CA, USA
Status: offline

The lack of feedback from IPACS on my problem is pretty annoying. I can't even get a reply to let me know they are working on it. . . or if they've even seen my posts. I guess this is another point to add to those many G3 vs AFPD threads. . . AFPD goes down and your on your own. . . and my 15 days are up. . .

_____________________________

-Brett
Northern California Aerobatic Club:http://www.iac38.org/

(in reply to teamsme)

Post #: 37

Page: << < prev 1 [2]

All Forums >> RC Airplanes >> RC Flight Simulator Software >> Ikarus AeroFly Pro and Aerofly Pro Deluxe >> RE: Official AFPD PPS variable pitch prop support thread
Page: << < prev 1 [2]

Jump to: