Joining Carbon Fiber Tubing (Full Version)

All Forums >> [RC Airplanes] >> Composites Fabrication And Repair

Message

---

Dave5cents -> Joining Carbon Fiber Tubing (10/11/2002 2:17 AM) What is the best way to join the ends of CF tubing? I would like to join two pieces at an angle to support the the wings on my parkflyer. In the past, I have used a bent piece of aluminum tubing that slip fit the outside diameter of fiberglass rods. The entire assembly was then epoxied together. Any ideas? Thanks. Dave

---

TiGuy -> Joining Carbon Fiber Tubing (10/11/2002 10:03 PM) Thats basically the same way I've been doing it except I use brass. If I'm making a straight join, I glue C/F or glass tube inside the tubes to be joined.

---

Page: [1] 1

SITE MAP!   : :   FORUM RULES RC Universe is a service of Internet Brands, Inc. Copyright © 2001-2013.

0.171875