RE: Welcome to Club SAITO !  
View related threads: (in this forum | in all forums)

Tower Hobbies
Enter up to 4 keywords or Tower stock numbers
Logged in as Guest



Users viewing this topic: krop, jetboy2003
  Printable Version
       

All Forums >> Glow Engines, Gas Engines, Fuel & Mfg Support Forums >> Glow Engines >> RE: Welcome to Club SAITO !
Page: <<   < prev  434 435 [436] 437 438 439 440 441 442 443   next >   >>  

Login
Message << Older Topic   Newer Topic >>
RE: Welcome to Club SA... - 5/31/2008 9:08:41 PM   
linkadrip



Posts: 1356
Joined: 3/17/2006
From: Tehachapi, CA, USA
Status: offline 		HAve to agrre there my saito .61 took a nose dive today into the dirt and i brought ity home Cleaned it up reall good put it on the engine test stand and Fired it up and still runs like new. Cant say the same for the pitts 40 it pretty much toast.. Time to find a new plane for my saito 62..

_____________________________

TwisT 150 Bro 12
AMA 888111 Club Saito 572

(in reply to Ed Cregger)
       Post #: 10876

RE: Welcome to Club S... - 6/1/2008 1:05:15 PM   
Ricky Blade


 

Posts: 50
Joined: 5/26/2007
From: Loxahatchee, FL, USA
Status: offline 		saito 125 exhaust troubles. what options are avail? flex pipe w/pressure tap? if so where can you purchase? seems stock set up is a little heavy and causing failures of the threads on the cylinder head, thats considerable weight hanging out there. i purchased a new head from saito but dont trust that w/stock pipe and muff it wont break again. someone HELP. thanks ricky.

_____________________________

MORE POWER SCOTTY!
I TELL YOU THIS ROCK MUST FLY!

(in reply to linkadrip)
       Post #: 10877

RE: Welcome to Club S... - 6/1/2008 1:34:56 PM   
w8ye



Posts: 17307
Joined: 12/11/2001
From: Taylortown, OH, USA
Status: offline 		The exhaust systems intended for the Y-S 110 will fit the Saito 125. Check with Central Hobbies

_____________________________

Attended the CutFinger Institute of DirtNap University for years but never did graduate....

Club Saito Member #7
Original AMA #31261

(in reply to Ricky Blade)
       Post #: 10878

RE: Welcome to Club SA... - 6/1/2008 4:13:17 PM   
jb86


 

Posts: 371
Joined: 12/20/2004
From: Ashburn, VA, USA
Status: offline 		http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXPXZ7&P=SM
tower hobbies masterairscrew 15x4, nylon, 4 stroke. they also work well on 2 stroke engines. i use a 12x4 on my os 46ax, cheaper than the apc 12.25x3.75. i was going thru them like candy, needed to saves some $'s.
jon

_____________________________

saito club #235

(in reply to Michaelh)
       Post #: 10879

RE: Welcome to Club SA... - 6/2/2008 3:04:05 AM   
rtn9105



Posts: 698
Joined: 8/12/2002
From: Hutchinson, MN, USA
Status: offline 		I'm looking for some info on how to change the bearings and then set the timing on my Saito 91. Is there a how to thread somewhere?

(in reply to jb86)
       Post #: 10880

RE: Welcome to Club SA... - 6/2/2008 5:17:45 AM   
w8ye



Posts: 17307
Joined: 12/11/2001
From: Taylortown, OH, USA
Status: offline 		http://www.rc-bearings.com/

Across the top banner there is a section entitled "bearing install"

With the engine at top dead center the dot on the front of the cam goes straight down

The little ends of the push rods goes towards the rocker arms

Set the Valves .002" to .004"

_____________________________

Attended the CutFinger Institute of DirtNap University for years but never did graduate....

Club Saito Member #7
Original AMA #31261

(in reply to rtn9105)
       Post #: 10881

RE: Welcome to Club SAITO ! - 6/2/2008 2:29:48 PM   
waterloged



Posts: 97
Joined: 3/14/2006
From: Gowen, MI, USA
Status: offline 		Hi All, I replyed quite some time back about joining club Sato. I ' m not so good withthe forums but after doing a search on "Waterloged" my handel it shows a hit in the forum bbut i don't seem to find it. Can you tell me what number or where i replyed to being a Sato member? I'm just curious where i am in the club as i replied a long time ago. Thanks very much...
waterloged.

_____________________________

Sato club member # 588
Once a Marine Always a Marine

(in reply to SigMan)
       Post #: 10882

RE: Welcome to Club SAITO ! - 6/2/2008 3:25:21 PM   
w8ye



Posts: 17307
Joined: 12/11/2001
From: Taylortown, OH, USA
Status: offline 		"BLW" keeps up with the Saito member numbers

When you find out what it is, put it in your signature so you will always have it. To put it in your signature you will have to go to your personal file.

_____________________________

Attended the CutFinger Institute of DirtNap University for years but never did graduate....

Club Saito Member #7
Original AMA #31261

(in reply to waterloged)
       Post #: 10883

RE: Welcome to Club SAITO ! - 6/2/2008 5:01:59 PM   
crashnburnrc


 

Posts: 8
Joined: 2/18/2008
From: Marietta, OH, USA
Status: offline 		Waterloged, You are on page 415. You were given club member #588.
Enjoy the club. Lots of good advise here.

< Message edited by crashnburnrc -- 6/3/2008 12:12:23 AM >


_____________________________

Member Club Saito #575
If it goes up, it will also come back down. Hopefully in a controlled manner.

(in reply to waterloged)