More G38 Questions  
View related threads: (in this forum | in all forums)

Tower Hobbies
Enter up to 4 keywords or Tower stock numbers
Logged in as Guest



Users viewing this topic: none
  Printable Version
       


BCMA-42 Pro - RTR
Seller:  blackbaron
Details:   $325.00   |  8/16/2008   |  Classified Ad
We will rotate YOUR AD in this spot if you select "Forum Featured" when placing or editing your ad!

All Forums >> Glow Engines, Gas Engines, Fuel & Mfg Support Forums >> Gas Engines >> More G38 Questions
Page: [1]

Login
Message << Older Topic   Newer Topic >>
More G38 Questions - 1/17/2002 5:39:42 AM   
vanguard



Posts: 259
Joined: 12/5/2001
From: Fairmount, IN, USA
Status: offline 		I am new to gas engines, hence, all of these stupid questions. But, I do appreciate the help.

1. Can the walbro carb. on a G38 be turned 180 degrees so that the linkage and adjustments face to the back instead of the front.

2. Is the black wire on the front of the coil, the one that I tap into to run a kill switch to ground.

Thanks for the help.
       Post #: 1

G38 - 1/17/2002 6:56:15 AM   
flyindy



Posts: 59
Joined: 12/5/2001
From: INDIANAPOLIS, IN, USA
Status: offline 		I don't think the carb will work at 180 degree change. The Horizon folks have an adapter out for the Zenoahs that will angle the carb so the throttle is a straight shot. I just got one for my G23, G45 and G62 and the G38 should be available very soon. This should fix the linkage problem.

As for the kill switch it is the small wire that the switch is attached to.

Hope this helps.

(in reply to vanguard)
       Post #: 2

More G38 Questions - 1/19/2002 4:18:35 AM   
rcign-RCU


 

Posts: 1040
Joined: 12/26/2001
From: Williams, AZ
Status: offline 		You can turn the carb any way you want to..You will have to make a new carb insulator block to get the crankcas pulse into the back of the carb to pump the fuel..You can drill a small hole in the transfer port, and install a small pressure tap..Tap another hole in the back of the carb, in the plate held on by one screw..There are two cast bosses in the plate, either one will work..Put a pressure tap in the plate and connect the two with a short piece of tubing..Been doing this for 15 years on my ignition conversions...

(in reply to vanguard)
       Post #: 3

Page:   [1]
All Forums >> Glow Engines, Gas Engines, Fuel & Mfg Support Forums >> Gas Engines >> More G38 Questions
Page: [1]





Jump to:


Google 



Search | Marketplace | Event Calendar | Local Clubs | Magazine | Product Ratings | New Products | Discussion Forums

Photo Gallery | Member Video Posts | RCU Video Gallery | Instructor Search | Field|Track|Marina Search

Advertisers | Hobby Vendor Resources | Rate Manufacturers | Sign In/Sign Up

SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.

Charities we support that also need your help
Yorkie Rescue | Humane Society | ASPCA | Crohn's-Colitis America

Kaango.com Classifieds

0.313RCU1