Tigger N. Bennie
Posts: 8388
Joined: 9/28/2003
From: Track, USA
Status: offline
|
quote:
ORIGINAL: mxrider99
where did my post go? did someone delete it?
Yes, I deleted it. I was going to PM you about it but since you already posted.... Here are the rules.
quote:
POSTING LINKS:
Our policy on linking to other websites is pretty simple. Members may link to any other site that provides information that helps answer another member's question or is just of general interest to members of that particular forum. One of the most basic tenets of the Web is the open exchange of information, and the RCU forum managers wholeheartedly support this type of exchange. Members may NOT link to sites which require registration or membership to view the content.
The only other type of linking (besides porn and spam as mentioned previously above in our rules, of course) that will not be allowed on our site is when members solicit people to leave our site to a competing service. That's just common sense. We won't allow people to use our site to promote a competing service any more than a brick-and-mortar store would allow his competitor to paste flyer's all over his walls. However, people are always welcome to link to any non competing online resource in order to share useful information with fellow members.
http://www.rcuniverse.com/forum/m_377662/anchors_377662/mpage_1/key_/anchor/tm.htm#377662
quote:
ORIGINAL: spooner
hey TNB don't do that again...i almost passed out..there was not (,)'s or (.)'s...i almost ran out of air reading it...
I wrote a gramatically correct two paged typed sentence once. I had to argue that one with the prof. 
_____________________________
Lots of RCs, two cats, and a Nikon.
|
Printable Version
All Forums >> RC Cars, Buggies, Trucks, Tanks and more >> RC Regional Racers & Bashers >> RE: 2006 Las Vegas RC Tracks & Events 
RE: 2006 Las Vegas RC Tracks & Events - 
That had to be one of the worse days I have had--fried an Airtronics servo in the 777 which I planed on racing before getting in one lap (no practice laps here). Then I noticed the servo wasn't centering when I went to run the