HoneyBee CP2 blades rotate the wrong way. (Full Version)

All Forums >> [RC Helicopters] >> Electric RC Helis



Message

Zik -> HoneyBee CP2 blades rotate the wrong way. (5/31/2006 10:55:53 AM)

Hey there. I had 2 honeybee cp2's. I used 1 for spares, but now i combined the 2 a bit to make 1 good honeybeecp2. But for some weird reason the blades are rotating the wrong way now :S So its giving negative downforce, and wants to go into the ground instead of going into the air. Does anybody has any idea what the problem can be? I just attached the blades the normall way. I didnt even remove them, and just removed and placed the whole rotorhead without deconstructing it, so that should be allright.



twistercp -> RE: HoneyBee CP2 blades rotate the wrong way. (5/31/2006 11:10:40 AM)

switch the motor connector round the other way?
blades should rotate clockwise



Zik -> RE: HoneyBee CP2 blades rotate the wrong way. (5/31/2006 11:11:07 AM)

i made a pic of the blades position while its rotating:

[img]http://img464.imageshack.us/img464/5341/blades8qr.jpg[/img]
(arrows are rotation direction (CCW)
As u can see, in this position the blades dont push any force down, but "cuts" the air and makes hisself wanna go down.. Does anyone know what the problem could be?



Zik -> RE: HoneyBee CP2 blades rotate the wrong way. (5/31/2006 12:38:44 PM)

Hmm, yeah it was only a matter of turning the connector around. I thougt the connecters only work on 1 way of connecting, so i thougt it was connected right. Sorry for the rather dumb question. Thx for the help.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.125