Add new fuel to old fuel or not? (Full Version)

All Forums >> [Glow Engines, Gas Engines, Fuel & Mfg Support Forums] >> RC Fuels



Message

Billy Hell -> Add new fuel to old fuel or not? (1/30/2002 10:38:47 PM)

I have a full jug of 10 percent 2 stroke fuel and a pretty old 1/4 jug of fuel I've been using. Should I add the new fuel to the old jug or fly out the old jug? I hate going to the field and carring two jugs when I know one would do.



Hircflyer -> Add new fuel to old fuel or not? (1/30/2002 11:35:07 PM)

I'm like you....I put the new in the old jug all the time. AS long as the fuel is the same brand I don't see a problem.. I've even mixed different nito strenghts.

Have never had a problem.



Homebrewer -> Homebrewer (1/31/2002 3:42:12 AM)

I do it all of the time. It DOESN"T even have to be the same brand. Just remember that mixing brands may cause your engine to run differently and you may have to adjust your high and possibly your low needles again to account for differences.



Billy Hell -> Add new fuel to old fuel or not? (1/31/2002 3:44:53 AM)

I was just wondering about water getting into the old jug. I guess this isn't a prob lem?



vertigo -> Add new fuel to old fuel or not? (1/31/2002 8:30:11 AM)

Water in the old jug could be a problem, if say for example it sat for a year with the cap loose.

I too top off the jug I'm using from with new fuel.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.140625