Zenoah G-23 Smoke? (Full Version)

All Forums >> [Glow Engines, Gas Engines, Fuel & Mfg Support Forums] >> Glow Engines



Message

slyguy -> Zenoah G-23 Smoke? (1/2/2003 10:01:41 AM)

I just read the article about the T-craft with the Zenoah G-23. It mentioned drilling a hole in the stock muffler for a smoke oil inlet. I have a Ultra Stick with a G-23 and was wondering if thats all I would have to do without having to buy an expensive muffler to add smoke.


Thanks
Ben Sly



jmercer52 -> Zenoah G-23 Smoke? (1/2/2003 9:49:29 PM)

It should work fine, just remember to put the inlet as close to the exhaust port as possible to get the best heat for the smoke, but not so it injects it into the exhaust port of the engine.
Suptter



slyguy -> Zenoah G-23 Smoke? (1/3/2003 5:54:57 AM)

Ok thanks


Ben



cappy1 -> Zenoah G-23 Smoke? (1/3/2003 7:43:07 AM)

take your fuel bulb, and fill it with smoke fluid, and hook it up to your smoke inlet and see if that works ok there. If not, plug the hole with a bolt and try again.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.078125