RE: Club 40 Racing Hangout  
View related threads: (in this forum | in all forums)

Tower Hobbies
Enter up to 4 keywords or Tower stock numbers
Logged in as Guest



Users viewing this topic: none
  Printable Version
       

All Forums >> RC Airplanes >> Pylon Universe - RC Pylon Racing >> Club 40 >> RE: Club 40 Racing Hangout
Page: <<   < prev  12 13 [14] 15 16 17 18 19 20 21   next >   >>  

Login
Message << Older Topic   Newer Topic >>
RE: Club 40 Racing Hangout - 6/4/2007 4:10:08 AM   
gunfighter


 

Posts: 646
Joined: 7/13/2002
From: Canyon Lake, TX, USA
Status: offline
You have got to be kidding!
Severence is a has been and Moody was a flash in the pan!
Professor Speed, Fast Eddie and the Kid will blow them all away!
I'm even thinking about reviving the Killer Bee with the "MONSTER"!

I've got some mirrors ready to take care of your Laser Range finder goggles!
And don't forget, MY plane is an ARCA member too!
but that is for NEXT month...

(in reply to Jim Duda)
       Post #: 326

RE: Club 40 Racing Hangout - 6/10/2007 5:42:42 AM   
gunfighter


 

Posts: 646
Joined: 7/13/2002
From: Canyon Lake, TX, USA
Status: offline
quote:

The CLAMS racing team intends to make it a clean sweep!


What is the saying..."It ain't braggin' if you back it up"!

The CLAMS team took High Points, Fast time and won the "A" main!

Watch out Team ARCA, team San Antonio, team Medina Valley, team Georgetown etc. we are coming for YOU!!!

15 pilots, 9 advanced - 6 novice. 3 plane heats in both classes.
LOTS of fun, heat, humidity and lots of close racing. Thanks to all for coming out and supoporting us. And special thanks to our volunteer judges Crash and Jeremy.

Full report in a few days I am sure.

(in reply to gunfighter)
       Post #: 327

RE: Club 40 Racing Hangout - 6/10/2007 2:36:09 PM   
SAPropbuster



Posts: 206
Joined: 3/7/2002
From: San Antonio, TX, USA
Status: offline
Severance here...

HAS BEEN, huh? Due to re-matrix, shoved to the Advanced 'B' main and WON, then 3rd in the 'A' main.... Not bad for a 'has been' Just where IS the Moody???


quote:

ORIGINAL: gunfighter

You have got to be kidding!
Severence is a has been and Moody was a flash in the pan!
Professor Speed, Fast Eddie and the Kid will blow them all away!
I'm even thinking about reviving the Killer Bee with the "MONSTER"!

I've got some mirrors ready to take care of your Laser Range finder goggles!
And don't forget, MY plane is an ARCA member too!
but that is for NEXT month...



_____________________________

Bob Severance

(in reply to gunfighter)
       Post #: 328

RE: Club 40 Racing Hangout - 6/10/2007 2:48:42 PM   
SAPropbuster



Posts: 206
Joined: 3/7/2002
From: San Antonio, TX, USA
Status: offline
Yeah...Seems that the HCAM guys have NOT confirmed the June 30th date??? Stan gonna have that super-duper timing system for a good work-out???? (he wouldn't bring it to SA..)

Waller Baby, watch your six!!!

....... and you may want to teach ur protoge' how to tune....... You CLAMS buddys need all the help you can get....

What hoppened to Fast Eddie???? He wasn't watchin HIS Six!!!

Trash talk aint' braggin!!



quote:

ORIGINAL: gunfighter

quote:

The CLAMS racing team intends to make it a clean sweep!


What is the saying..."It ain't braggin' if you back it up"!

The CLAMS team took High Points, Fast time and won the "A" main!

Watch out Team ARCA, team San Antonio, team Medina Valley, team Georgetown etc. we are coming for YOU!!!

15 pilots, 9 advanced - 6 novice. 3 plane heats in both classes.
LOTS of fun, heat, humidity and lots of close racing. Thanks to all for coming out and supoporting us. And special thanks to our volunteer judges Crash and Jeremy.

Full report in a few days I am sure.



_____________________________

Bob Severance

(in reply to gunfighter)
       Post #: 329

RE: Club 40 Racing Hangout - 6/10/2007 3:41:20 PM   
gunfighter


 

Posts: 646
Joined: 7/13/2002
From: Canyon Lake, TX, USA
Status: offline
Yea Bob - you did pretty good for a "has been"!!! In all fairness, I must say that Bob was tied with me for high points. I won the tie breaker due to a faster time during the heat races.

"The Kid" does need a litle coaching. I set up his engine and he won his first heat ever. Against Ray Allen, no less! And had fast time for a while. Then the next heat while I was busy as a lap counter, he starts it up and immediately starts turning the needle!! His engine would not come up at he start and he gets a DNS. What can I do??? He is 18 and "bullet proof"!! He will learn eventually.

Fast Eddie was the victim of a "fly by cut" that took his tail feathers off around turn 1 in the second round.

Lot's of fun yesterday! Looking forward to the next dance!

(in reply to SAPropbuster)
       Post #: 330

RE: Club 40 Racing Hangout - 6/10/2007 3:47:48 PM   
gunfighter


 

Posts: 646
Joined: 7/13/2002
From: Canyon Lake, TX, USA
Status: offline
BTW - I think Moody knew he had a target on his back and decided to sit this one out.

Ray Allen was tough all day. He had fast time for the heat races.

A little "power tune up" and a "special prop" gave me the edge in the "A main.

(in reply to gunfighter)
       Post #: 331

RE: Club 40 Racing Hangout - 6/11/2007 1:22:44 AM   
gunfighter


 

Posts: 646
Joined: 7/13/2002
From: Canyon Lake, TX, USA
Status: offline
HCAM has confirmed they will host the June 30 race!

I hope Stan will bring out his timing program - have not heard for certain.

Hope every one shows and supports this new venue!

See ya there!

(in reply to gunfighter)
       Post #: 332

RE: Club 40 Racing Hangout - 6/11/2007 2:37:22 AM   
SAPropbuster



Posts: 206
Joined: 3/7/2002
From: San Antonio, TX, USA
Status: offline
Excellente!

_____________________________

Bob Severance

(in reply to gunfighter)
       Post #: 333

RE: Club 40 Racing Hangout - 6/11/2007 1:52:44 PM   
StanDouglas


 

Posts: 113
Joined: 8/28/2003
From: Austin, TX, USA
Status: offline
I'll be there. I'll need to have the HCAM car battery and an inverter to power the equpment. If we're going to use the NMPRA race program to generate the matrix and do the scoring it would be nice to pre-register as many pilots as possible so there's less to enter on race day.

Cheers,
Stan

(in reply to SAPropbuster)
       Post #: 334

RE: Club 40 Racing Hangout - 6/11/2007 2:29:49 PM   
gunfighter


 

Posts: 646
Joined: 7/13/2002
From: Canyon Lake, TX, USA
Status: offline
I have been asked to CD the HCAM meet so I will use the same manual matrix I used at Seguin. Every thing is already printed up.
I would appreciate it if all pilots would pre-register so we can have frequency conflicts resolved ahead of time.
e-mail me at chuckstt@gvtc.com to pre-register.

(in reply to StanDouglas)
       Post #: 335

RE: Club 40 Racing Hangout - 6/11/2007 5:24:59 PM   
Oldbob


 

Posts: 158
Joined: 6/29/2005
From: georgetown, TX, USA
Status: offline
Looks like I missed a good race. However I did enjoy a lot of good softball. Our team came in third.
I will be there on the 30th

Preregister info:

Bob Petrinec
AMA 3532
Radio Ch. 34
Advanced

(in reply to gunfighter)
       Post #: 336

RE: Club 40 Racing Hangout - 6/11/2007 6:35:22 PM   
SAPropbuster



Posts: 206
Joined: 3/7/2002
From: San Antonio, TX, USA
Status: offline
Pre-register information:

Bob Severance
AMA# 7989
Radio Channel 49
Advanced

_____________________________

Bob Severance

(in reply to gunfighter)
       Post #: 337

RE: Club 40 Racing Hangout - 6/15/2007 5:05:53 AM   
Ken Erickson



Posts: 308
Joined: 12/17/2005
From: Columbus, IN, USA
Status: offline
The new flyer has been posted. Current South-Central Texas Schedule

Ken

(in reply to Ken Erickson)
       Post #: 338

RE: Club 40 Racing Hangout - 6/15/2007 5:33:22 AM   
waydar


 

Posts: 32
Joined: 3/19/2006
From: Summerfield, FL, USA
Status: offline
Hey All Y'all....This Saturday.... Club 40 will be racing at The Ocala Flying Model Club and everyone is invited to come race or just kick back and enjoy the racing. Hope to see some of you at the race.

Take care

waydar
Summerfield FL.

(in reply to Ken Erickson)
       Post #: 339

RE: Club 40 Racing Hangout - 6/17/2007 6:36:11 AM   
havac21


 

Posts: 5
Joined: 3/13/2007
From: Colby, KS, USA
Status: offline
After my 3rd crash with my Skyraider Mach II I decided to spruce it up a bit. the all white color scheme can be a bit hard to see at times. I'm in the blue jeans with striped shirt hoping that my second year of RC will be less disastrous although I have really enjoyed the rebuilds so far. The skyraider at my feet is missing everything from the leading edge of the wing forward.

Attachments
Click to see fullsize image.
Click for fullsize