|
cflytrap -> RE: has anyone used the walkera 64c (5/20/2008 4:53:05 AM)
|
quote:
Nice to know model flies OK. I am setting up the 64C for its maiden flight - can you advise on the settings you used (Pit,throttle, gyro,.....). Instruction booklet has me a bit confused re these basic settings and also re the setup gyro settings.
First thing is unplug your motor, and turn on your TX.
Ok assuming the helicopter swashplate and head linkages are setup correctly, and your transmitter is zeroed out, your should have 0-2% positive pitch at 50% throttle ideally depending on your flying style.
to adjust pitch turn on the #10 DIP on the back of the TX. this unlocks v1 and v2 and allows you to influence your collective pitch. v2 is your overall collective pitch adjustment. if you turn this to the right + the overall up and down range of motion becomes greater, which will make your model more agressive. decreasing tv2 shortens the amount the collective pitch travels and makes the copter more docile. v1 is the throttle curve and in my opinion is tricky tricky. If it is at zero, the throttle will respond proportianally and equally with your throttle inputs on the tx. if you go into the - the model will have its blades pitched earlier when you throttle up. If it is into the + it will gain more headspeed before the blades get pitched.
I never mess with the gyro. set the rudder extent to what it needs to be and turn the sensitivity to about 75%. Do nothing thru the Tx.
V!
|
|
|
|
