GAU-8
Posts: 263
Joined: 1/25/2008 From: houston,
TX, USA Status: online
|
well i got it working again, but i still cant tighten up the slip, like other have done to get the insta-wheelies.. is the inside of the thread plastic on the nut? as soon as it touches something it will spin and spin, but not get tighter. but it wont come off unless i unscrew it. if i hold the tires, spur gear can be rotated maybe 120-180 degrees before it stops. normal i guess. cant get it any tighter than that though. but tonigjht i did mod it. i got my7.4 - 1300 MAH lipo out, and converted it to accept the car battery connector. while the body sits higher up, and the shocks are a little saggy with the weight in back, i get over an hour run time. (but i run for 10 minutes, and cool down for 10) going to get some springs and BB motor for it today i think. if local hobby shop carries em.
< Message edited by GAU-8 -- 6/23/2008 3:28:15 PM >
|