|
rhod-z -> more eq 10 power expander questions (3/1/2007 1:38:34 PM)
|
rrritchy,
thanks for your quick responce on my last questions its alot clearer now but i have a few more questions right now i am setting my giant up and i have a JR xp7202 radio but i am going to purchase a 10x in the future so i am going to buy a jrpr2100 10 channel rx and install it in my giant my question is the two power lead from the power expander, the instructions say to use channel 1 and 10 for power input but the channel 1 for the jr reciever is throttle and the p.e. instuctions say not to use the battey supply port on the rx or the reciever will think its in "direct servo control " if i use channel 1 and 10 do i have to reconfigure all my switches and gimbles? or can i use say channels 9 and 10 for my redundant setup?
Thanks,
r.od@hotmail.com Robert
|
|
|
|
