Zenoah starting problems (Full Version)

All Forums >> [RC Helicopters] >> RC Helicopter General Discussions



Message

imtheone -> Zenoah starting problems (2/11/2003 10:15:57 PM)

I have a new z230 with a zenoah I got it to run for about 15 minutes first tank. now I get it to fire then dies right away I ajusted low needle to 1.1/4 turn and high to 1.1/2 and open them a little more still no good even put in a new Plug. I am useing Zenoah oil with 7 ounces per gallon of mix Any Ideas sure could use some Thanks Imtheone


[email]hueyp@qnis.net[/email]



Furyflyer2 -> Zenoah starting problems (2/11/2003 10:17:28 PM)

Could your choke inadvertently closing as it's running?



Malorie -> Zenoah starting problems (2/11/2003 11:19:24 PM)

Set your needles to 7/8 on the low and 1 1/4 on the high. Dry out the plug and try it again. Your needles are WAY to rich. With 7oz. per gallon you may need to go even a bit leaner (by a bit I mean maybe 1/16th turn or so). 7oz. per gallon is a bit much on the oil also. You can break it in on 6 and move to 5 or 4 after the first gallon or so.

Good Luck,
Malorie



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.140625