HS 5945 on elevators different speed (Full Version)

All Forums >> [Radios, Batteries, Clubhouse and more] >> RC Radios, Transmitters, Receivers, Servos, gyros >> Radio Manufacturer Direct Support >> Hitec/MultiPlex Radios- Ask Hitec Customer Service



Message

zzw26n -> HS 5945 on elevators different speed (3/16/2007 11:46:00 PM)

Team Hitec,

Question; Setting up a CUDA with one 5945 on each Elevator half and according to the Programmer, speed, deadban, are the same. But when I move full up, the LH side gets there first and faster. I also noticed with my Futaba 14MZ when I just nudge the elevator stick, the LH elevator moves and the RH doesn't? Using 9 channel Futaba PCM Receiver.

Any thoughts? thanks

Loyal Hitec Customer, Ward



mglavin -> RE: HS 5945 on elevators different speed (3/17/2007 12:24:17 AM)

Ward,

There are many varaibles even though everything seems the same.

Allow to me to dig up some previous info on this subject and I'll get back to you ASAP.



zzw26n -> RE: HS 5945 on elevators different speed (3/17/2007 2:21:24 AM)

thanks Mike ...



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.0625