Yak 86" Control Horns (Full Version)

All Forums >> [RC Airplanes] >> Giant Scale Aircraft - 3D & Aerobatic >> Quique's Aircraft Support



Message

RCFREAK -> Yak 86" Control Horns (4/5/2007 9:57:08 AM)

Heya Dudes,

Im just up to installing the control horns on the Yak now, im just wondering about the little square plasic/fiber sheets, do they go under the control surface? One of them broke does it matter?..

Do you cut off the covering in the shape of the square and glue the whole assembley on or just cut out the slots for the horns and thats it?

Thanks Guys



octanehuffer -> RE: Yak 86" Control Horns (4/5/2007 10:22:28 AM)

Mine were pre slotted and just slid over the horns after gluing in place. I thought they were there to A) cover the excess glue and B) hold the covering down. Being as thin as they are I cant see them doing much more than that. No need to cut away the covering. Hope this helps.
Adam



Barry Cazier -> RE: Yak 86" Control Horns (4/5/2007 3:18:31 PM)

[:)]I kinda thought they were a measure to let you know when the horn was in all the way. I removed the covering between the two slots and let the epoxy that ozzed out glue them in place. I doubt they add any strength to the joint.

Thanks
Barry



RCFREAK -> RE: Yak 86" Control Horns (4/5/2007 4:18:02 PM)

Thanks Dudes, one more question on the tail wheel install.. The blind nut and hole do not match up.. Do i just drill out the hole a bit more?



Rezagh -> RE: Yak 86" Control Horns (4/5/2007 8:37:06 PM)

Yes, just drill the hole a little larger and use a washer.


Thank you,
Reza



RCFREAK -> RE: Yak 86" Control Horns (4/6/2007 1:36:44 AM)

Thanks Rezagh



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.3125