86" Horns (Full Version)

All Forums >> [RC Airplanes] >> Giant Scale Aircraft - 3D & Aerobatic >> Quique's Aircraft Support



Message

RCFREAK -> 86" Horns (5/9/2007 11:10:52 AM)

Heya dudes, i just finished gluing in place the control horns for the elevators, i didnt use the little plastic square base thingos. Will this be ok?



Rezagh -> RE: 86" Horns (5/9/2007 3:23:18 PM)

As long as you have glued it good, you should be fine:)



RCFREAK -> RE: 86" Horns (5/13/2007 2:24:36 PM)

Thanks mate



pani -> RE: 86" Horns (4/1/2008 11:27:40 PM)

Hi Reza,

Further on this, is it ok to cut the covering under the square bases and use epoxy there as well?

Thanks
Panos



Rezagh -> RE: 86" Horns (4/2/2008 12:09:31 AM)

You really don't need to cut the covering, make sure to iron it down pretty good but if you'd like other than the look, it would be 100% fine to remove the covering and glue it:)



pani -> RE: 86" Horns (4/2/2008 7:47:24 AM)

Thanks Reza[sm=thumbs_up.gif]



pani -> RE: 86" Horns (4/2/2008 1:10:23 PM)

Hi Reza,

Your valuable help is needed again.

Moved on to the rudder horns.
They are both identical with one nail each (when I say nail I mean the small intendention on each).
Should they both go in from the same side or one from each side of the rudder? It confused me and the pictures are not quite clear.


Thanks again for all your help

Rgds
panos

PS BTW should there be a canopy cover as well in my kit? There wasn't one in there.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.140625