needle valve 90lx (Full Version)

All Forums >> [Glow Engines, Gas Engines, Fuel & Mfg Support Forums] >> Engine Manufacturers Direct Support Forum >> Jett Engineering Support



Message

phjoker -> needle valve 90lx (6/11/2007 6:50:44 PM)

Igot my 90lx back from dubb last week with a clean bill of health.
I am putting it in a great planes cosmic wind minnow. Do you have any pictures of the
needle valve set up for the minnow? I mounted it on the firewall but it is not in line with the carb.
it is a littlehigher.If you have any pictures of other setups that would be great
Thank You
PH



bob27s -> RE: needle valve 90lx (6/11/2007 7:18:23 PM)

Hey there.....

I cant find any needle valve photos off hand, but a bit out of line with the carb is ok. It really is not that critical. Half inch either way should work without any issue.

Let me know how the setup works out for you.



phjoker -> RE: needle valve 90lx (6/12/2007 8:08:52 PM)

thanks I am going to try and run the engine today if I have time. I will take some pictures of the setup



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.125