SBV2 Pro placement (Full Version)

All Forums >> [RC Cars, Buggies, Trucks, Tanks and more] >> Academy Racing (MRC) Support



Message

annie_himself -> SBV2 Pro placement (7/7/2007 8:33:21 PM)

How many ways can the electronics be placed on the buggy? I've only seen the normal SxS setup and no saddle packs, 4x2 setups or anything. Has anyone tried them? Also, can the motor be placed in the front opposite the servo if the top deck was flipped around?



Davey G -> RE: SBV2 Pro placement (7/9/2007 6:41:50 PM)

Hi,

No the motor cannot be moved forward. 4 x 2 battery setup is achieved by taping the 2 cells in on the opposite side of the 4 cells. The 4x2 setup increases steering, this car already has a ton of steering so most team drivers are sticking with the std 6 cell Side by side setup. Hope this helps, talk to you soon!



annie_himself -> RE: SBV2 Pro placement (7/12/2007 2:50:11 AM)

Thank you.



Pit Bound -> RE: SBV2 Pro placement (7/20/2007 5:09:30 AM)

We are running the V2 Pro with the standard 6 cell battery set up on a hard pack surface that is a little loose. No problem with steering at all. If you want steering going into the turn, try the one way on the shaft. We run it and you can hit the corner hard, brake and still steer! Squeeze and it pulls you around the trun...[sm=cool.gif]




annie_himself -> RE: SBV2 Pro placement (7/23/2007 3:44:05 PM)

Ok, good to hear. Thanks again.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.1054688