RCV 90SP Loose Throttle Arm (Full Version)

All Forums >> [Glow Engines, Gas Engines, Fuel & Mfg Support Forums] >> Engine Manufacturers Direct Support Forum >> RCV Engines Support



Message

Corwin38 -> RCV 90SP Loose Throttle Arm (8/12/2007 3:31:00 AM)

I am getting a lot of play in the throttle arm/ring on my 90SP (throttle arm will rotate a couple of degrees before the carb opening moves). Has anyone else had this problem? How can I tighten it up?



shonny -> RE: RCV 90SP Loose Throttle Arm (8/12/2007 5:03:50 AM)

Is the grub screw on the side properly tightened?
If so, you need to gently punch the lugs on the front holding the arm till there is no movement.
Same problem on a Saito .91 was solved by using two 0-80 button head screws to hold the arm in place.
Screws and tap are available from Micro-Fasteners, who are the BEST!
shonny



Corwin38 -> RE: RCV 90SP Loose Throttle Arm (8/12/2007 12:36:51 PM)

Thanks Shonny, it was the lugs. Light tap on each one fixed it.



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.09375